$32 FIX - FORD HILL DESCENT ISSUE - 5 MINUTE Fix 

Dude you are the freaking GOAT for making this video!!! I seriously can't thank you enough!! I was about to rip my hair out trying to figure out what the hell was wrong with my car. I even changed the transmission fluid thinking that that was the problem. I'm beyond relieved that a simple, $30 part ended up fixing the multiple issues I was having. You're the man for making this!!

Thank you! I drove on some snowy roads with 4-wheel drive. Dropped it back to 2-wheel drive and parked it. I'm unsure if that caused this, but that was the only thing out of the ordinary. I went into the house, and about an hour later, my wife said, your truck lights are on. Thinking it was a dome light, I went out in the snow in my basketball shorts and T-shirt. I ended up spending the next 30 minutes troubleshooting. My back lights were on even when my car was off. The "Hill Start Assist Not Available" warning showed on my dash when I started my car. I did a little research and found this video. I bought the part and switched it out. I had trouble getting the old switch out; give it a good, healthy twist and pull it straight out. I found the replacement part for 17.99 at O'Reilly's. THANK YOU!

What a legend. Still saving people hundreds. Thanks man

I have to say thank you bro so I had the same problem but with my 2015 Ford Mustang where my car wouldn't accelerate past 60mph and then I would always get Hillis Asist not available on the dash and I also notice that I was able to turn the car on without pressing on the break so that was a sign that that sensor was bad so I swapped it for a new one and everything is back to normal on my Mustang so thank you so much for saving me time and headaches

Great video ! Fixed my problem in literally 10 mins . Thanks

I have been having this problem and have been so frustrated. Diagnostic showed nothing. Thank you!!!

I cannot THANK YOU enough for taking the time to post your video. I was anxious about this issue and was prepared for an expensive fix. Your video was a tremendous help. I especially want to THANK You for including the box with part number. I was in and out of AZ in 5 mins. Great stuff, and Thanks again.

Bought it for $70 from part source in Canada and can’t thank you enough my guy 🤝🏾

BROOOOO!! You saved me hundreds of dollars in sure. My truck started flashing the same signswhike driving in the freeway. It just so happens while in driving past a ford dealer here in Houston at 500pm as I just got off work. When I stopped and asked them to take a look they were a week and a half out on service and could not look at it any time soon. Thinking I would have to call a tow truck and have it towed cause I was reading everyone else going thru similar situations and having to replace a throttle body or other things I stumble on your video and seen you have the exact same year and models mine. Googled a auto zone and they had 1 left so limped my truck there and changed it in the parking lot a 30 dollar fix!! Thanks for posting this video brother!!! You saved me lots of time and money I'm sure!! My baby is up and back in the road again. 🍻🍻🤘

2013 f150 getting hill descent fault and service advancetrac. I swapped the brake light switch, and the problem appears to have disappeared after 30 minutes of driving. I had seen these suggestions buried in a few forums, then saw this video. Decided $32 was cheaper than any other potential troubleshooting. Hopefully this fixed root cause for good. Thanks for posting!

Wow what an inexpensive fix vs taking to the dealership. THANK YOU so much. No more issues/errors. It was scary while towing an RV to have to pull off a narrow road

My man. You just saved me hours of troubleshooting and made it a much cheaper fix then I thought it would be. 2015 Ford Edge, same problem, same fix. Much appreciated.

I can’t thank you enough for posting this video and saving me so much money!! Like so many others, my 2015 Ford Fusion after the Hill Assist Not Working message inexplicably came on and it started driving strangely. Saw this and got to Auto Zone for the part as fast as I could. My hubby had it fixed in less than 15 minutes! THANK YOU!!

Alex you are Da man. This happened to me today. I went right over to auto zone and 34 dollars later I'm back on the road. Thanks a ton man.

Im stuck on the side of the road and seen your video. I have a part on its way to be replaced. Your amazing, thank you

My friend had the same issue we were at work and I came out during lunch time and notice his brake lights were on. well we tried everything we could the brake light off, including the cargo light button, the brake forward and backward adjust button, nothing would work to get the brake lights off, on our way home the dash started bringing up all those error Messages about hillasist. I have no idea how i stumble upon your video but after watching it i fixed the truck with the same part another $32 fix thank you I really appreciate it

You the man Alex. This happened to me a couple of years ago and I got fleeced at the QuikLane. Happened again yesterday and I got it sorted in like an hour. Appreciate your video!

Thank you SOOOOOO much for posting this. What a nice thing to do. Saved me time, money and a huge inconvenience!!! You rock!

I cannot thank you enough for posting this video, I have a show this weekend that’s very important and today all of a sudden my truck started bogging and my brake lights wouldn’t turn off. If I wouldn’t have found this video I would still be searching for throttle bodies in rack and Pinion since my truck is out of warranty I cannot thank you enough sir. Send me an address so I can send you some chocolates 😂😂

Dude, I could kiss ya on the forehead! Thank you so much. You saved me a rental car and no telling how much Ford would have charged me. I bought part and replaced. Like 2 minutes of work and it's repaired. 😊😊😊😊

I will pile on. Not sure how much you just saved me but I know it was a lot. For others reading comments, my issues were brake lights staying on, hill descent message, and my engine causing deacceleration once I hit about 40 mph. I thought for sure it was a computer issue that was going to cost me $$$$$$$. It was this $35 part. Took me 5 minutes to replace. Thanks big time Alex

I had all the signs and symptoms ( 2015 F-150 ) you described in this video. Followed your lead and bammm. It worked!! Thanks a bunch for sharing this video!! GB you!!

Mate you are a champion. I had the identical problem and removed the switch. Opened it, cleaned the terminals and it all seems good now. Just about to do a road test. Road test was okay except when I tap brake the cruise doesn’t switch off. I have to push the brake a lot more to make it switch off now. I found the mistake that caused my second self inflicted fault, make sure when reinstalling the switch the little black rotary part is lined up with the blue catch prior to pushing the switch through the hole, THEN rotate it to lock it in place.

Thank you so much for this video!!! You got a new subscriber.. We changed the brake fluid little tank and the booster cylinder then the “hill assist not available” came on. We were going crazy!! I have a 2016 F150 XLT the number part for that is SW8241- Stoplight Switch. I hope this is helpful for other people.

This video just saved me! My truck literally had all these symptoms thanks for the video

Just had the same issue. Noticed my brake lights were on and couldn't get to accessory mode either. Thankfully I went this route as well. And it seemed to resolve my hill decent fault and lost of power/acceleration. Great video, wish I saw this earlier. 👍

Thank you so much for posting this!! My husband was going to bring his truck into the dealership after saying he already tried to look up what could be wrong with it. Although he didn’t include that hill assist start wasn’t available. So glad I looked it up after he told me he already did lol I swear some men think they know better than women sometimes. And it’s not the first time I’ve helped with issues such as this 🤦‍♀️

I have a 2015 XLT and it worked. Thank you so much!

Worked for me. Hill assist fault and back light wont turn off. Changed this sensor and truck is back to normal!

I have all the same symptoms will try tomorrow thank you

You deserve all the good in the world....thank you

I thought I had this exact problem. I bought the part from the video, and when I went to install it, I realized there was a small landing pad on the brake arm that the actuator hits. Well, my little landing pad was shattered and partially missing. The actuator was extending the thickness of quarters when the brake pedal was at its resting position. The over extension told the computer I was pressing the brake….I taped two quarters together and taped them where the little pad was, and all my problems went away. I’ll see if I can find the actual pad replacement somewhere. 2015 lariat F150…but thank you for the video. It got me looking in the right area…..can anyone else look to see if their pad is missing or damaged?

Thank you for this video! Just saved my 2015 F150 was definitely stressing about it being something worse.

Just want to thank you for this video our Ford truck 2015 150 was doing the same thing took your advise and it worked thank you 😊 🙏 so much

My truck just got these symptoms today, I’m going to order that part and hopefully that fixes it!

OK, Thanks for the video. My 2015 just started doing this. It really freaked me out when it did it the first time. It seemed like it happened when I was going at a slow speed (say about 30-35mph), tap the brakes and then accelerate. I'm not certain of that pattern. I shut the truck down, waited a minute and then restarted and it acted normal. It did the fault a few days later and it took 2 shut downs to get it to reset. After that I went to the local emporium and got the part and put it in. I haven't had any further issues, but I haven't driven it that much yet. We'll see...

Thanks a ton man! This fixed my “Hill start assist not available”. It was $32 at auto zone. It sure was a bitch removing the switch even after I turned it a quarter clockwise. Almost had to break the old one to get it out. New one went in easy.

Thanks for the help. Less than $20 to fix. Thanks

My 2017 hill descent light came on showing its off. And something about advanced trac off. No problem w it running. Same fix ??

What is the name of this switch mine just started with this problem 🤣 and I have to fix it my brake lights won’t turn off so I literally disconnected the battery 🤣 🤦‍♂️

Thank you for the video!! This fixed my issue too! Saved me a lot of time and money!!!

good work!!!! ps. whens the next scout vid really wanna see the body fitment with the new motor!

Nice video man, I think this is the problem I'm starting to develop. Doesn't happen often but when it does I'm usually turning left or right at a slight incline downhill so I'm going to try this first, thank you

Brooooo!!! Thank you so much for this video. Had Same exact issues tha you described. Got my part from oreileys for 17.99. 2015 f150 xlt 5.0 v8. Good as new 👍🏻

Thanks

Thanks , this was very helpful, saved me money big time

Life saver best tip on the net here!

Thanks to you but most importantly my best friend Roger for if it wasnt for him , he would not of referred me this video!!

On my fusion 2014, the switch is stuck. I rotate it clockwise but didn't turn much all I hear one or two clicks. kept trying until I broke the plastic pad (stopper) and it fell down 🤦‍♂️

I have same problem with my ford explorer 2016 , is it same part or it's different!! Thanks for helping ppl bro ,God bless

Thank you for that i will try to check that out on my focus.

I’ll try it and get back to you

Thank you so much, just solved my problem!

I got the hill clime assist malfunction after replacing the steering knuckle. I’ll be it shorted that out

My 2016 Ford Explorer showing all those lights 😿I hope the same part will fix the problem

Great Video Bud, Thanks!!!

So is this the same as HILL START ASST NOT AVAILABLE? I HAVE A 2016 F150.

These new vehicles are sooo over engineered…..if you need help holding the brake while on an incline you shouldn’t be operating a motor vehicle.

Hello, good evening, I hope you respond to my comment, I have a Ford Fiesta 2013 S and the brake is on on a slope and when I put it on R or D it just doesn't move, I have to accelerate a little and that happens every time I stop a stop or traffic light, do you think that's the solution?

Happened today.. brake lights on and friend out in a new switch but the wrench sign came up after. Does it just need to reset?

Thks! I'm curious if this it's called the same on a 2014 and if it in the same place?

We're you also getting hill decent control fault and pre collision assist not available?

Headed to get the part now! Thanks!

Preciate it brother, huge help!

you think this would work on the Ford Escape 2016? That hill assist is not fun to go thru when you are driving in traffic or anywhere.

Huge thanks!!!

Thanks. Your solution worked.

Thank you

My 2015 fusion is doing this right now! Did your truck go into limp mode?

Do you just pull the piece out, it’s so hard to get out?

Thank you brother!

Maybe having same issue right now. Where is this part located on the truck?

Thank you. Very helpful.

Thanks for the vid. It worked

Thank you very much!!!!

Awesome !!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Thank you!!!!

I bought that part and didn’t work for me. My issue is pretty much the same but when stopping on hill. Feels like the brakes don’t release after letting go of the brake pedal. Took it to the Ford dealership and they are useless. They say that can’t fix it if it doesn’t give them a code.

Where do I put in

Sure miss my 1966 mustang. NO computer anything anywhere. Keep a spare set of points in the glovebox and go for 50,000 miles. No bs. Drive your own new car for less than $3,000 and be able to maintain it yourself with minimal tools. Don’t have to rely on China for chips or anything else.

Does this work for a 2015 hybrid fusion?

all Fords have the same issue!!!! everyone!!!

Feels weird when pressing the brakes

Did not work for me

This did not work

You have an odd accent. I replaced this part yesterday. I got it at the dealership, $74.00.

There is a thumb button on gear xhifter

Did not fix