2003-2009 Dodge Ram 5.9L/ 6.7L Cummins Transmission Cooler Installation Guide by Mishimoto

Подписаться 61 тыс.

Просмотров 82 тыс.

50% 1

2003-2009 Dodge Ram 5.9L/ 6.7L Cummins Transmission Cooler
www.mishimoto....
Engineering: engineering.mis...
Facebook: www.mishimoto.c...
Twitter: www.mishimoto.c...
Instagram: www.mishimoto.c...
MODEL: MMTC-RAM-03SL
Fits all 2003-2009 Dodge Ram 5.9L & 6.7L Cummins*
212% Increase in core volume
244% Increase in fluid capacity
159% Increase in fin surface area
Includes fully serviceable thermostat for fast warm-up in cold climates and thermostat bypass for constant cooling in hot climates
Stacked-plate design for tough and reliable cooling
Eliminates corrosion-prone quick-disconnect fittings
Mishimoto Lifetime Warranty
Disclaimer
• Please dispose of any liquids properly.
• Allow vehicle to cool completely prior to attempting installation.
• Mishimoto Performance (MP) is not responsible for any vehicle
damage or personal injury due to installation errors, misuse,
or removal of MP products.
• MP always suggests that a trained professional install all
MP products.
• Do not run the engine or drive the vehicle while overheating.
Serious damage may occur.
• Raise vehicle only on jack stands or on a vehicle lift.

Опубликовано:

14 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 41

@happycamper5193 3 года назад

I installed mine on yesterday 2007 5.9 Took me about 3.5 hours but I cleaned my radiator, inercooler, ac condenser real good x 2. When I removed transcooler I covered everything with double sandwich bags and taped off openings. Cleaned real good. Very simple install. I just took it to my transmission shop. For service drop pan tighten bans, filter and new fluid. I have that done yearly. I pull a 40 foot fifth wheel. After adding the mag tech deep dish pan and this trans cooler. I hope to see better temps pulling when is 100 degrees out side. Time will tell.

@91rangerturbo 2 года назад

did you ever see a big increase? are you still running the factory heat exchanger also?

@tylermoffat6051 9 месяцев назад

What did you use to clean your rad.. I'm going to do the same.. and tranny oil all over it from leaking cooler

@mercedes-amgforlife3237 6 лет назад

Will be buying one of your trans coolers very soon for my 03 Dodge 3500. Been on the Cumminsforum following this thread for some time now.

@mercedes-amgforlife3237 6 лет назад

Got it via UPS a few days ago and can't wait to install. Am glad the kit uses rubber hose instead of the factory conmections as my aftermarket I.C. and boost tubes rub the lines. I can route the runbber hose to avoid problems. Thanks again Mishimoto!

@r6mikeg 6 лет назад

Time to order one for my build 68rfe. 2009 ram 2500

@yerwrng 5 лет назад

So the 2008 trans cooler does indeed have a thermostat for cold warm up .This explains my erratic behavior with temps and the dealer said early year 6.7s did not have a thermostat for cooling bypass for cold warm up, well it's not the first time a dealer told me wrong. May as well replace the stick unit with an upgraded one ...lol... it always make the time spent feel less of a waste when it's upgraded parts going back in .

@jarrington1950 5 лет назад

Does anyone have some real world numbers on this installed? How does this compare to added an aux electric fan cooler under the truck?

@cliftonsargent1572 6 месяцев назад

So Tran’s cooler is in front then intercooler is behind?

@mishimoto 6 месяцев назад

Our transmission cooler sits in the OEM location, between the intercooler and radiator.

@tristanscalf5047 Год назад

will this fit with the banks intercooler installed?

@mishimoto Год назад

We have not tested with competitor's products. Sorry!

@cesarfilho477 5 лет назад

Does that requere additonal fluid on the trans? Because I assume that this one is a larger one, meaning less oil avaiable on the gear box...

@mishimoto 5 лет назад

There will be an increase of 0.88 qts

@rogershirt115 2 года назад

Will that fix it from getting Transmission hot on a 2500 2009

@mishimoto 2 года назад

Yes, this will help.

@rogershirt115 2 года назад

Thanks

@garrettcarpenter3319 2 года назад

What is the part number for 03 dodge 2500 Cummins?

@mishimoto 2 года назад

MMTC-RAM-03SL www.mishimoto.com/dodge-ram-2003-2009-59-67-cummins-transmission-cooler.html

@Kellengravesfab 5 лет назад

How much in temp will this allow for in additional cooling

@mishimoto 5 лет назад

We saw a temperature reduction of 10°F at the cooler inlet and about 13°F at the outlet vs the stock unit.

@sssfs9418 4 года назад

@@mishimoto for only 13°F it's not even worth the effort and let's not even include the huge cost attached to Mishimoto products.

@steve5912 3 года назад

@@sssfs9418 🤷‍♂️

@monkehbitch Год назад

@@sssfs9418 for a fix all and a stock upgrade because the stock thermostats are known to stick, running a but trans, mine runs at least 20°f cooler with the bypass valve installed. I've not had the trans fluid hit temps anywhere near where stock cooler was while off roading, towing or idling in stop start traffic.

@ohvblue 5 лет назад

Installed my cooler today. Bummer it sits behind two ugly coolers Haha

@watchman6104 4 года назад

Mine came with some silver metal plug type thing. Said nothing about it. What is it for?

@mishimoto 4 года назад

Sounds like the thermostat block off. Please contact us at support@mishimoto.com if you have any additional questions.

@watchman6104 4 года назад

@@mishimoto Thank you. I found another video explaining what it is. I'm glad you guys included it!

@rogerstubert 5 лет назад

Yep and how much is this gonna cost now

@Mjb317 5 лет назад

Will this work with the factory heat exchanger deleted?

@mishimoto 5 лет назад

As long as your lines still lead to the OEM point used you should have no issues.

@Mjb317 5 лет назад

Mishimoto Automotive okay so might need to run extended lines, is there enough room for an E fan?

@Redsfanatic32 4 года назад

Yes. Just make sure you keep the thermostat in. I’d also recommend running a derale remote cooler with a fan on it for additional cooling or you’ll have issues during warmer months.

@91rangerturbo 2 года назад

@@Redsfanatic32 even with the factory heat exchanger deleted and no thermostat?

@Redsfanatic32 2 года назад

@@91rangerturbo yes. Especially when towing and not in lockup, or in heavy traffic. One of the heat exchanger’s jobs is to keep torque converter heat flashes down. Fluid heat exchangers have a lot higher BTU rating than air to fluid ones. Even without a thermostat I would regularly see 170-180 if I was doing a lot of stop and go driving. I never towed with that setup though. I put the thermostat back in the mishimoto cooler and installed a remote cooler under the transfer case and even when towing heavy in the heat of summer the highest I see is about 170. I recently bought a thermal bypass that 6.7 trucks use because my remote cooler is a free flow cooler without any provision for keeping heat in the fluid, so it’s going in line to bypass that cooler unless I really need it. 48s and 47s absolutely hate cool fluid temps. Anything below 130 and mine seems to shift sluggish and lockup is really spongy on the apply. So I highly recommend you use a thermostat

@worlds_okayest_cummins 2 года назад

Does it matter which hose goes on top or bottom?

@mishimoto 2 года назад

It does not.

@BentonL Год назад

@@mishimoto The valve in the cooler has to have a preferred flow direction doesn't it? That's why I am here. 4:20 You labeled the top one as feed line in this vid.