Тёмный

2004-2021 Subaru WRX STI Compression test guide // **EASIEST WAY** 

Oldie Productions
Подписаться 8 тыс.
Просмотров 11 тыс.
50% 1

Today we'll be walking through how to do a compression test on a 2009 Subaru WRX STI. This process is the same no matter what year STI you have!
-------------------------------------Social Media-------------------------------------
-My Instagram: / oldieproductions
-------------------------------------------Song-------------------------------------------
Netrum & Halvorsen - Shivers

Авто/Мото

Опубликовано:

 

7 окт 2022

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 25   
@Hustler_state
@Hustler_state 4 месяца назад
Did you ever figure out anymore about this? Just curius ive had very similar lower consistnt numbers across all the cylinder on a cold engine, but im getting like puffs of smoke upon a cold start like a bad turbo seal, replaced tubo same, replaced pcv twice, same, all new valves were done and all new pistons and machined seals all of it. So im trying to understand if it was shitty mechanic with the valves or something with the crank case oressure or what.
@Lumlums
@Lumlums Год назад
You know what I got the same numbers with my harbor freight tester and I wonder if it’s the tester showing low??? Or if all my cylinder are low.
@OldieProductions
@OldieProductions Год назад
I don’t remember where I bought my tester, I wanna say advance auto parts or one of the larger auto parts stores. I’ve used it on a few Subarus and have had somewhat normal results from most of them. I think this car having such high mileage the numbers make sense.
@smithwrx5910
@smithwrx5910 5 месяцев назад
spun bearing?!
@AutoExpectations
@AutoExpectations Месяц назад
Stock block can hold every bit of 600 whp. 500 safety.
@leandropim
@leandropim Год назад
(16 sti) My engine is shaking and i tested the cylinders, the cylinder 2 is low (60psi) but i tested the injector of cylinder 2 and it is leaking, sorry my poor english, but what do you think about the engine, a leaking injector can cause low psi cylinder?
@SubOptimal_
@SubOptimal_ Год назад
sounds like you need a new motor man
@jorclon
@jorclon 11 месяцев назад
How bad is the shake?
@zakiramjan9822
@zakiramjan9822 9 месяцев назад
excessive fuel can wash out the cylinder. That's why it lost compression. Could be the rings or the crosshatch marks are gone.
@michaelcarter3149
@michaelcarter3149 6 месяцев назад
60 is pretty bad, unfortunately I have that beat on my 04. 30 psi on cylinder 4, all others 120. Just going with a jdm swap and build the old motor if it's still good.
@thedigitalidiot
@thedigitalidiot 10 месяцев назад
Do you have to floor the accelerator when cranking or is that only for the older stis?
@jackemarleeyoung
@jackemarleeyoung 7 месяцев назад
Its safer to pull the fuel pump fuse and unplug the crank position sensor. Some have had the engine start and redline on occasion by trying to do a flood start.
@nathanacuna
@nathanacuna Год назад
Nice dIy, tear down would be a lot of fun!
@OldieProductions
@OldieProductions Год назад
Will be coming soon fingers crossed!
@MichaelPSmith-mp1fk
@MichaelPSmith-mp1fk Год назад
What ended up being the verdict? Also, how would you do wet compression test with a boxer?
@OldieProductions
@OldieProductions Год назад
@@MichaelPSmith-mp1fk No verdict yet, haven't pulled the engine.
@BoostedFA
@BoostedFA Год назад
Fun my ass... its a ringland failure.. time to tear the car apart. 😒
@OldieProductions
@OldieProductions Год назад
@@BoostedFA Some of us enjoy doing teardowns and rebuilds. I'm not 100% certain that it's ringland failure in this case, because the car has near perfect compression across the board. If one cylinder had way less or no compression at all that would indicate ringland failure. I'm 99% positive this car has rod bearing failure, hence why it's knocking so loudly.
@brandonsalas6552
@brandonsalas6552 Год назад
Ouch poor thing sounds hurt 🙁
@thintz
@thintz 3 месяца назад
KNOCK KNOCK WHO'S THERE? iT'S ROD ROD KNOCK
@brandonsalas6552
@brandonsalas6552 Год назад
Simple answer it wasnt taken care of in mechanics eyes maybe speed hungry kid’s opinion of taking care of
@goatlocker219
@goatlocker219 2 месяца назад
Not necessarily. Our STI's ringlands failed at 69k. It was not modified and only driven by my wife and I and we're both over 40. It's just a terrible engine and there are a number of lawsuits because of it.
Далее
Why your Subaru doesn't need 500hp.
27:07
Просмотров 11 тыс.
$21,000 vs $43,000 Subaru WRX Build - HiLow FINALE!
23:41
How to SUPER CLEAN your Engine Bay
21:58
Просмотров 50 млн
SUBARU Engine Rebuild - EJ20 / EJ25 Teardown How To
18:12
Why Subaru Engines Blow Up!
36:43
Просмотров 318 тыс.
Fixing the "Blown" Subaru WRX STI...
25:52
Просмотров 222 тыс.
Cylinder Leakdown Test (Easy 3-Step Method)
5:41
Просмотров 37 тыс.
профи на Тракторе Т-16
0:24
Просмотров 2,4 млн