Thank you so much, my rear lights and climate lights weren’t working due to being rear ended. That fuse is in this box and I couldn’t get it open! This video saved me!
Hey man my battery and break light go off and on on my 06 G 35. I have installed a new battery and new terminals. At first the problem was fixed . About 2 miles into my trip the battery and break light go off. Not as much as before the installation. I deeply appreciate it!
Derek Torres Bro These are a few questions to ask. Did we install anything new like stereo etc..? Check grounds. Have you done a load test on the battery? What kind of readings you get? Check voltage on alternator. This could be an issue that’s about to happen. You didn’t mention anything about the car cutting off. You do have an electrical issue the matter is going to have to be resolved systematically. Start with battery, alternator, and terminals cleaned. Let me know thanks for watching. Also you may have a leak which has gotten on the alternator which could be causing this issue. So look there too.
I need some help man. I removed my battery and everything. I cannot get the box to come off the bracket. i hold both the clips on top and the bottom, etc. it moves a little but does not come off. Any idas? maybe i am doing something wrong? I held all the clips at the same time, but nothing. DOES NOT WANT TO COME OFF lol S.O.S
Steve Amuz Whats up my guy..The 2 clips on the top are all you need to press to remove it. Like I know you’ve done that already so my only other suggestion is investigate why the 2 clips on the top are not working looking for movement of the lever at it engaged point. Perhaps someone didn’t seat it correctly back on the bracket and that’s what’s hanging it up. TBH it should just slide up without a lot of force. So something is hung up on the backside pointing towards the fender. Good luck to you and Thanks for Watching 👍
Thanks I needed that to replace a fuse I blown for my driver seat and interior lamps, all them went out when I replaced the lamp bulbs with LED ones, I’m guessing the driver seat and lamps are controlled by one fuse being that I lost controlling of the driver seat when the lamps blew out
Hey bro my vdc warning light turned on the other day and hasn’t turned off I was wondering if you might know what’s wrong. I added brake fluid already and it’s still on. Maybe the car needs an alignment ?
Thanks for Watching Bro. Brake Pads Low? You said you had to add fluid, that could mean brakes worn low. Maybe reset the ecu. The steps are Disconnect neg batt and pump the brakes. To discharge capacitors in ecu. Let me know🤘🏼
Larrythefisherman just like 4 or 5 pumps. So have the car running. Then turn off and then disconnect batt. Leave your door opened. Then pump breaks 4 or 5 times. Then wait a few minutes. Then connect back up. Hope it helps. I just did it a few minutes ago to clear a code. MAF .
Quick One thanks bro that didn’t end up working but I did do that pedal trick. It was much more complex but it worked lmao. Thanks for looking out bro I appreciate it!
Murda 4hire I’ll really shoot Bro power windows fuse is under the battery cover. It’s the long rectangular box in front of the battery. 2:12 in video. Thanks for watching
@@tgreen200 do you know how to fix the key fob that don't want to lock or unlock the doors but will recognize the fob once I'm inside to start the car 07 infinite g35
I’m thinking something may be wrong with the remote keyless entry receiver. Look this over Keyfob signal is inputted to remote keyless entry receiver (the antenna of the system is built in remote keyless entry receiver). Remote keyless entry receiver sends keyfob signal ● to BCM terminal 20 ● from remote keyless entry receiver terminal 2. The remote keyless entry system controls operation of the ● power door lock ● hazard and horn reminder ● auto door lock ● map lamp and ignition keyhole illumination ● panic alarm ● trunk lid opener ● keyless power window down (open) OPERATION PROCEDURE BCM can not receive signals (except keyless power window down signal) from keyfob when key switch is ON. Let me know. Thanks for Watching
Which fuse controls interior lights, power tilt steering wheel , and power seat? I tried “room lamp” and “meter/bat” fuses but no luck! Also tried disconnecting battery but still no luck! Infinity does poor job of identifying which fuses control auto components? Any help appreciated.
Hey thanks man this is Gerilyn. I finally found out they’re fucking little lie hide and seek game in my fucking fuse panel. I’ll see what they did and I see what they put in there. That should’ve been in the buses. They are fucking done. Thank you so much man.
benji benji Bro the fuse that controls the Bose amp is the same one that controls power to radio so if the radio is on then the problem is within the Bose amp. The amp sends signal to all speakers even the sub woofer amp also Bose amp location is in trunk underneath carpet just above the rear left tire..Thanks for Watching.
NjBori_G35 . Bro Thanks for Watching. If you wanna disassemble it it’s probably held together with various clips for those inserts with the wires.. it shouldn’t be too hard to tackle without step by step. I just look at things how I think it works and go from there.. reverse engineer it..👍🏼
@@tgreen200 same here for some reason i couldn't pull the whole box out like u did...think the wire is caught on something. I just needed to open it to pull the fuel relay.but I replaced the injectors with out pulling the relay.said fuck it
I have an 2009 g37xs and on your video I saw a fuse for fuel pump do you know if there is a fuse for the sending unit too? cuz my gas gauge is not reading the gas level properly and I have change them both but the problem keep persisting ??
BOSS TANG Just looked at supercharging it BTW. Costly. I’m just starting out with the Mods. Intake Exhaust. Next Art Pipes. Hope you get your lighter back Bro I use mine too. Not for charging as the manual says not too.
flipmode00 squad Try doing and instrument cluster self check. Ignition Off. Press and Hold Trip A/B. Turn on ignition (push 2X) with foot off the brake. Let go of the A/B switch and push 3X’s This will make the display flash several times and Now you can push & hold the trip switch to cycle thru to see if the fuel gauge responds or is stuck. Should get half way on fuel gauge I believe. Let me know.
Thank you for this video - I was really struggling to check my DTRL fuse and this did the trick! Oh yeah, fuse was fine so now i need to replace the bulbs!
Bro so when you depress the top 2 clips it should slide straight up I just took mines out last night. Possible it’s snagged but it will give you some resistance cause of the cord on the bottom. Let me know if you get it. Thanks for Watching