2011 Mitsubishi Outlander Shock replacement 

That's awesome.... I like how you've edited out most of the information that no doubt brought most of us to the video, i.e. How you got your hand into the area where the top nut is located, etc.!! Genius!

Thanks for the video! I replaced the struts on a 2012 last weekend, for a single mom in the National Guard. Upon driving it back to her house, I felt and heard the rear shocks had gone bad as well. Gonna tackle this install for her tonight -- saving her $1,500 in labor is my good dead for the month. :-) This video will save me loads of time, so thanks again! Edit: they made changes in the 2012 -- you need a spring compressor as it is wrapped around the shock. Such a nightmare.

Thanks for uploading the video!

Thanks mate. Those top bolt access ports are so small!

Thank you very much indeed for this video. I'm just about to tackle this. Some say removing the side panels make access easier. But looking at it, I think that would be harder than the shock! 😂 Thank you again 👍

wait, im confused.. so did you just clean off the old part & reassemble it or did you replace it with a new part??

Thanks brother good stuff 👌

Great video sir !!! Thanks a million.

Nicely done video except you left out the torque values and the link in the description doesn't work.

Thanks,what was the tourque setting please.

If you went through all that trouble, is there a reason why you didn't also change the springs at the same time ???

Where can I get rear shocks stucks 2014

i have the same car. can you give me the suspension model? thanks

Realy safety 🤣🤣🤣

That is awesome but no