2022 Can Am Outlander 1000 XMR Snorkel Install 

I listed part number at 2:07 in video

I have not noticed that. But I haven’t sent it full throttle yet. I would imagine that if there were any kinks on the intake pipe it would be biased to collapse. I spent a lot of time making sure it was not bent when the covers were on

@@kurtatv2315 I just took videos of it, I don't see any kinks in the pipe. The pipe just feels too flimsy. As soon as I hit 28mph it starts to choke and won't go over 30mph. I also noticed if I have to give it any throttle to go up a hill it chokes. If I put the stock pipe back on I get over 40 without any issues. I am working with the dealership on a refund

@@scottwollschleger6155 I will definitely watch for it next time I go out. Thanks for watching my vid for the heads up on issue. There are other kits but this one looks so clean… sorry you had this challenge

@@kurtatv2315 I figured can am sold it so it would work without issues, guess I was wrong. I will figure out some type of pipe to use in it. Probably flex pvc. I do see the clutch exhaust through is just as low and is not rerouted higher so not sure what this is getting you

Actually I don’t think you don’t really need to cut that hole. It doesn’t hurt to cut it either. It might have made fitting it a little easier but not really required. The cvt exhaust is rerouted back down into the atv there. Two of the videos I watched from the creators I listed did not cut hole. One just cut the existing support leaving a big hole showing (again no real impact). Was there a reason you cut the hole that I overlooked? I can still go back and cut it.

@@kurtatv2315 In the installation instructions it shows you utilizing the C2 & C3 template when utilizing a NEW gauge support. The stock XMR gauge support has holes cut on the LH & RH side. You CAN re-use the stock gauge support… however when installing the snorkel horn the existing hole on the RH side will be exposed. I opted for a new gauge support with no holes. You still need the LH hole cut as nothing is changing on that side. The breather point on the RH side is now being relocated to the center… and will use the C2 template through the gauge support and new breather tube goes through this into the raised horn. You also may need to use the C1 template for the console support. This piece of plastic is exposed after you remove the gauge support. I’m not sure if you used this template or not. Either way…the directions clearly show the LH hole being either recut into your new gauge support OR simply cut the middle C2 hole when using the old Support. I hope this makes sense. Basically your just deleting the RH hole and moving it to the center….. all else stays the same. FYI I have seen others relocate the loose breather tubes as you did and route along the new snorkel breather tube. I left mine alone as I just wanted the look. I’d post photos if I could figure out how.

My 2021 the dealer was looking at my problem for 6 months I had a hard time with them my bike was also the losing antifreeze from day one 3 hose we're leaking through that threads plastic gooseneck from Factory was flipped over and leaking my dealer wouldn't believe me or something they couldn't find it so they say just when the warranty was up I took her to another dealer 8 months in total they put on more km than I did I have 800 I may have went three anyways you want to keep a lookout on your antifreeze seem like every 2 months it would be completely empty it was empty when I brought it from the dealer have a good one