Very Nice! In Part One you set up a roughing toolpath, I didn't see you use it in Part 2... any reason why not? Also, a good suggestion for a video would be to show how to use your Mach 3 software.... Thanks
I realized that with these tapered ball nose bits and the soft pine wood -I didn't need any roughing pass :) - there has to be tons of Mach3 videos out there - but I could probably make one too :)
Would you put part 1 back up, I would like to lean how you put the file together. I am new to cnc and was in the army. I would like to make one for myself. Thank you very nice work. I am going to fell your channel.
Is your spoilboard 2x6 boards? That's amazing!! Curious as to what you're using to sand the piece with. What is it called and where can I find one? Both vids were great and thank you for your efforts to share and teach us noobs how to do this.
New Sub here... My Q is about your Blue Bristle Brush on your drill. Can you describe that to us (Grit, etc.), and where did you pick that up from? Thanks! P.S. Beautiful machine you have there!
That info is covered in part one - but it's a .75mm tapered ball nose bit (amzn.to/2UEWPAr) and what's nice about them is you can usually get away without a roughing pass (if the engraving is not too deep) so the depth of cut on this one, at it's max, was like .25" or so
Hello, sorry to bother you again. This has to be the newbiest question ever lol. When my machine is doing the rough tool path it is cutting way too deep making my cnc head struggle. Is there a way in aspire where I can tell the machine how many passes and how deep to go in the roughing step?? Thanks :)
@@markisherecanada No problem! When you pick the tool for the roughing job there will be some options for the tool, and the one you want to look for is "Pass Depth" - I usually set that to the diameter of the tool or less depending on how hard the material I am cutting is
Look for "Tapered Ball Nose" - these are my favorite bits amzn.to/3dwP2li - the smaller the tip the better resolution, but also the longer time it takes to carve :)
The original machine was one bought off of eBay, so no official brand - and then I upgraded nearly everything on it - bigger motors, stronger rails and supports, etc... so it's a "Franken" CNC ;)
@@Engineering_Science I've probably spent way too much, because a lot of experiments that didn't quite work out or were swapped out later - I can't really say how much I've spent since I didn't really keep that good of a track of it
@@HoarderOfHobbies Well that was a learning experience you had for having the time to do the experiments. I'm now considering to simply buy a precision Matthews bench mill and convert it into a CNC which the include's the CNC kit, costs about $6K shipped into the house.