3D-Printing the Mulholland Drive Box and Riveting! 

Oof, that jawdropping joke hurt a little haha

Thanks for your great video! Nice print in place design you have created and I like that you've included a test piece. This saves a lot of time, energy and plastic if it turns out that it needs tweaking. I'll keep that idea in mind!

The test part is soooooooooooo nice and smart. Many thanks for including it

Awesome! I like your design philosophy. I was just designing some boxes myself using bolts as hinges but I'd like to try some print-in-place stuff too. I have a question regarding the design though. When designing the hinge for instance, do you simply make the axle slightly smaller than the hole it's seated in? I feel like you would need to get that offset right to prevent the entire thing from binding up while printing. Do you have any tricks or is it just a lot of iteration with different sizes and printer settings? Again, great video!

An iron, I should have thought of that! I have been trying to melt filament with a lighter and it does not work so well. Cool box!

No Hay Banda!

do you use SUPPORTS?!

👍👍😎👍👍

That's never the wrong movie :-) (at 1:33).

you don´t need an iron, if you have a lighter or matches

VBW alligator pliers...