Finally found a nice press to restore! This beautiful blacksmithing tool is used to bend, cut, drift and punch steel, but with different dies can assist in many other operations.
This press has a particular frame construction called "A-frame" that should be more rigid than other presses but restrict the operation because materials can be loaded in only from the front. Two weights at the bar ends are there to add momentum that help maintain the shaft in motion. It weights 57kg (125lbs) and measure 50x21cm by cm tall (20x8in wide by in tall) with the screw shaft 4cm (1.6in) in diameter.
Although very rusted and chipped the press was in great mechanical condition, seems like it has been well greased over time, all thread are still in perfect condition.
It came with a "FERRE" marking punch but I have no idea of what that is and I can't find any information about it. The word is very close to "ferro" italian name for iron.
Index of operation and materials:
Disassembled with the help of rubber mallet, wd40, heat and elbow grease.
6:33 Electrolysis: water and sodium carbonate solution, parts connected to negative side and steel sacrificial anodes to positive sice of a DC power supply (car battery charger). 2-3 hrs at 10amp.
9:44 Rust converter applied to clean steel for black patina. Resist very well rust if not scratched.
11:00 Generic paint stripper.
12:27 Dark green, hammered finish, paint
13:11 Assembled with grease and white mineral oil
Thank you a lot for watching. See you next week!
★Patreon★
/ blackbeardprojects
★Website★
blackbeardproject.com/
★Follow me★
Facebook ► / blackbeardprojects
Twitter ► / blackbeardproje
Instagram ► / black_beard_projects
31 май 2018
