AEM XSERIES OBDII Set Up in HPTuners Software 

I was wondering how I’d install the pair of x series I picked up. Thanks for this video. Cleared up a couple things I needed to know that the instructions don’t. Have a good one

I tried to hook mine up exactly. The gauge works. But when I add the channel it doesn’t work

So what happens when you search it so many times to the extent where it disappears on the channel list (wb eq) cos I don’t seem to find it again?

What needs to be done to get HP Tuners to pickup native Air Fuel Ratio rather than Lambda?

I followed the instructions in the video but when I connect the MPVI2+ scanner to the passthrough from the AEM wideband, it only reads the wideband and not the car. I have even replaced the gauge and the wiring but it still only reads the wideband. If I remove the passthrough and connect the MPVI2+ to the OBDII port directly it reads the car just fine. Is there some other setting that may be off?

Would this wideband also work on a 2005 wrx tuned on opensource via tactrix cable?

Whats part # for 2nd AEM wideband, looks like different obd2 connector than connector on 30-0334 ???

How does the Bosch 4.9 LSU compare to the proven NTK wideband sensors?

will this gauge allow the standard hp tuners to have a wideband signal on the hp graph?

Will this work with LiveLink?

Do you need the upgraded box for this to work, or will the standard one do fine?

I did this and the VCM scanner doesn’t display the data?

how to use this with Evoscan?

The music is distracting.

Only works on 2008 and newer obd2 CAN Bus. Dosen't show up on my 2003 Silverado