Aisin Manual hub (free wheeling hub) rebuild Toyota Land Cruiser 

I really appreciate your time, effort, & knowledge, that you have shared with others like me. It is extremely helpful &, in my case, faithfully applied. Please keep up the good work.

Your comment is awesome and revealing! Thanks for watching!

very instructional. when i get my hubs done will check your video first. Thanks.

Just what i needed thanks alot for the video, nicely done.

Great video,thanks for sharing.

Great Land cruiser videos, I've got a 1hd-t and was wondering if you could please post a video on injection pump tuning.

fantastic vid thanks

I use factory gaskets always. Thanks for watching!

@bobcyrus Yes I suspect I didnt have to do it - so it isn't on the video - next summer I may make a video on that.

@farmdownunder Thanks very much!

Yes, What I was looking for was the proper tensioning spring arangement. The only part you skipped by?

@scottycombs Thanks very much! Don't forget to subscribe for more helpful videos.

you refer to synthetic bearing grease, but what kind? I got Mobil 1 synthetic grease it look just like the grease you said was wrong. So which vendor are you recommending. And I love the video, I had no idea on how to do this. thanks

Free wheeling hubs from FJ-62 are the same than FJ/BJ 40 series? there's a couples of TLC FJ-62 at a scrapyard near home which could be good donor for my BJ-40.

HI mate. Do you have a part number for the Longfield Chromoly Inner Hub Gears? I'm rebuilding some Aisin Hubs for my Colorado and want to make sure I get the right ones.

what did you use for gaskets?

There are TWO springs connected to the inner hub gear, One is neither mentioned or shown here...

Hi! I am doing some maintenance on my original toyota power locking hubs, wich i am chamging to manual ( just got some adapted hub covers). I have got mp grease, devron starolex ep2. Is it good to lubricate the hub?

Hi, Do you have any idea what control electrical on Hub motor to rotate in right and left or do you have a wiring diagram on it

Sorry but you missed the part about how to fix the pawl to the hub clutch.. with lipping the tension spring over the two smaller tabs on the pawl. :)

did you use a hub body gasket ? the O shaped one?