Aluminium Slug Mould for the HDR50 & 68 - by Alternative Mag 

Bruh... That Track You're Playing is Legit.

I purchased the 68 one a few weeks back, very good results been putting 177 promethius and large ball bearings they rip straight through bean cans 16j version

Nice indoor review Ben on a cold and rainy day outside. To make life easier, either just slightly underfill all the chambers with glue gun glue, these slugs will still perform well, or use a single sided razor blade (the ones with the protective steel strip on the opposite side of the razor blade to hold it safely - glue gun glue is notoriously hard to cut with any knife, so the very sharp razor blade works much better (mind your fingers!) 👍👍

HDX68 Can use ?

I seen the HPA video and I just recently purchased a couple adapter's and it got me thinking now you have 2 access points to for a tank I have a couple Air Venturi 3000 psi with the 1100psi regular. So if there regulated 1100 psi can you use 2 tanks same time? In the name of science of course !!!! Would it work and get twice as many shots or just go real bad just thinking. Great video

The weight on the lead balls ? .50 caliber. Nice video❤

...Just fill just to the top (not past) that way you will have a Nice Divet in the slugg ....With NO Trimming!! Try it! TIP: ...You don't need to fill full mold ...try half filled!! ....PLUS ...TOSS THE GLUE AND USE WAX ....MUCH CHEAPER...

good video...!!! ..what weigth have ?. it's dangerous with that knife :)

NICE👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍