Analog Circuit Design Engineer Interview _Plot op-amp Vout, V-, V+ when switch is 0 and 1

Подписаться 2,3 тыс.

50% 1

**
Analog Design Interview/Screening Test questions for Texas Instrument ,Micron Technology, ST Microelectronics, Synopsys, Steradian semiconductor, NXP Semiconductor, Analog Devices, Intel, Samsung etc.
*You can join our Telegram group for solve your doubts/get prep materials/discussion-
t.me/+SKZ-Dksf-cdhNjFl
All important interview question-
*Analog Design Engineer Interview Question:
• Find small signal Vo f...
*You can connect with me on LinkedIn- / amitbarju2023

Опубликовано:

18 июн 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 11

@srijandwivedi294 Месяц назад

Sir very good content Just the volume is low sir else very good video sir

@amjathhusain8605 Месяц назад

Thanks for bringing such good questions...When the switch is open Vx = 14.57 V , Vy = 14.16 V and Vout = 15 V..

@AllenSA_Lily Месяц назад

Sir very good content

@asitbar3986 Месяц назад

Nice content

@priyansukarmakar9787 Месяц назад

Sir for 2nd case V0=A( (v1+6v0)/7 - (v2+5v0)/6) V0(1-A/42)=A(v1/7-v2/6) V0 =-2 and should be 0 where I am wrong ?

@harshitmittal3784 Месяц назад

Vo should be 0 as V- is coming out more than V+

@harshitmittal3784 Месяц назад

also V- and V+ values will change

@AmitBar-Analog_Circuits Месяц назад

When the Opamp is saturated,then the Opamp is dead,,,so Opamp doesn't put any effect on the circuit

@harshitmittal3784 Месяц назад

@@AmitBar-Analog_Circuitsopamp is saturated but towards Vss i.e 0v as the answer you found is not satisfying +ve f/b where v+ should be greater than V- but your v+ is coming less than v- which means+15v is not correct. If u keep o/p 0v and then calculate v+ and v- then u will get corrected results