Super helpful video, do you have any tips about how to get the front lower arm back into the end alignment? Got the ball joint in the spindle and attached back to the shock, but just cant get it back into the final back alignment to screw in
I noticed you did an alignment a few months before this job. 2 questions: Did you change the driver's side as well? Did you do alignment after this job?
I used this one: www.amazon.com/OEMTOOLS-26553-BALL-JOINT-SEPARATOR/dp/B0955H22QD/ref=asc_df_B0955H22QD/?tag=hyprod-20&linkCode=df0&hvadid=532546161982&hvpos=&hvnetw=g&hvrand=4394053596716579959&hvpone=&hvptwo=&hvqmt=&hvdev=m&hvdvcmdl=&hvlocint=&hvlocphy=9003205&hvtargid=pla-1423949755333&psc=1
Hello ✋🏻, i need your advise please. My ride is Audi A4 2006 2.0L ... I had a complete set of control arms replaced today (total 10pcs), and being aligned afterwards, but unfortunately i experienced a very stiff steering wheel. Any clue ?
Hey Dave, thanks for replying . In fact, i left the mechanic garage and drove 16 km to home. And its insanely stiff. Do you believe i should give more time ?
Was there before replacing the suspension?? Check the u joints of the steering column inside and outside the car , if u have steering wheel light on can be some malfunction on the steering on electric rack
Why did you replace the entire control arm? My independent German vehicle mechanic said that I need to replace the entire arms because all of the bushings are shot. Why not just replace the bushings? He’s quoted me over $900 for the job.
My issue was a worn and loose outer ball joint which is an integral part of the arm and cannot be replace separately. If your bushings are shot then the ball joint is probably not far behind. The entire arm cost $125 from Autozone. A Genuine Audi control arm will cost you $440. I think $900 is a bit much and probably what a dealership would charge if not more.
@daveraymond2265 really good video. Did you had any vibration in the steering wheel while braking? Got a knocking noise from the front while I drive slow and slightly press the brakes through potholes or pull hard and when I'm doing 70mph and press the brake I get a bit of vibration in the steering wheel. Thanks