BLEEDING THE FUEL SYSTEM ON JOHN DEERE 

Just a a pointer. When using the fuel pump to bleed the fuel system, you just need to turn the key to the run position and you should be able to hear the pump pumping since it is an electric pump. You do not need to crank the starter.

You can fill the filters with diesel before you install then there will not be much air left to get out of the system.

One farmer to another, thanks for posting this video!

Good one dude . Perseverance paid off ! Saved you a call out fee and mechanics rate . I always study up as I'm about to go into hills of Waitomo NewZealand to do same job on a JD 6200 . The farmer ran outa diesel . It should have an electric pump . Anyway thanks man .

Turn the key on few times then start it , it might die once but usually start right back up only need to open front bleeder half turn

You're supposed to bleed it at the final fuel filter -

I found a very fast and easy way to check for fuel leaks and pressure up fuel system. Remove fuel tank cap and cover opening with rubber or old shirt, or anything. Pressure up tank with air blow gun.

Lo q pasa q ami le susede lo mismo pero se me quedan seco el filtro mas grande de diesel

I have a 5095m with the same filter set up. Of course the dumbed down operators manual doesnt cover how to change the fuel filters or how to bleed it. Does anyone know the proper procedure? That longer filter screws me up every time.

So my dodge you can drain the water while the engine is running. I tried that the other day on my JD and it died in about 10 secs. Lol. I had to learn how to bleed the lines and prime the system about like what you are doing here. Wish the pump would put out more flow.

You should have turned engine over a little and pump would have been on back of cam lobe and then pumped fuel

Will the engine speed up before dieing then refuse to restart if there is air in the line ?? Mine is a John Deere 5400

I think you were on high cam the first time and the pump was not working..

You should not be making videos you should not even be working on your own tractor you have no idea of what you are doing other than making viewers dumber, God bless your mom

First you should learn how to bleed the air out of your fuel system before you actually do it on camera. You don't even know how to actuate the lift pump, so get someone to explain that first. Good luck, you need it. Thanks for trying anyway.