BMW F11 rear passenger carpets wet - water leak fix. 2011 model 

I've just done the rear nearside door on my 2014 F10 530d. Your video, and the similar one by MekanikArnas, were invaluable. Thank you! Wouldn't have attempted it otherwise. As you suggested, unplugging the wires made it a lot easier. Couldn't believe how much force was required to get the door card off, especially the first trim clip or two.

Thank you! Worked like charm. My tip, if you have troubles removing old buytl from the door (on a hot day) I recommend using duct tape (I used 3M) to do "depilation" :) of buytl material.

Hello David, thanks for this video. Today changed adhesive tape and it solved water accumulation problem.

The first plastic bit doesn't need to be removed , you just need to access the screw 👍

It's the window seal that is the problem not the glue holding the internal panels on. Replace the window seals.

On my car there was a lot of butyl but its 2012 and now its 2023 and it lost its capacity to bind and seal. Good video

Many thanks - having the same problem. This is very helpful.

Easy to follow .. thanks for posting!

Not taking away the cause or half solution. If it not runs on the carpet, the door get filled. In fact it's a design mistake for many years. My E39 525D of 2003 had the same problem. You've an inner rubber sealing and an outer rubber sealing on the door. The two rubber taps under the door are in between, so if the outer sealing holds it can still get in. Also the door might get partly filled. The best way would be to drill a hole, outside the door outside the outer sealing of the door, near the outside of the door itself on deepest point use a bit Zink paint and tectile to protect the hole. Many cars have this standard

Update : yep that was the problem! I’ve put the new adhesive and it sort the problem out. Thank you so much.

But how does the water get into the inside of the door even if the seal behind the door card is bad? Shouldnt the outer rubber trims prevent water from getting in there?

Thanks for the video. Very informative. I have that operation to perform on my 1 series later in the week.

Had this problem on my f30 .., in passenger front . For the life of me I thought who was coming in my car with wet boots all the time . Couldn’t figure out why it was always wet .. my fix was to sell car fuck having these baffling issues . Have a Audi now no more wet carpet .. happy days

Just read the comments. Have the diameter. Thanks.

Thanks for doing this video. Did you have to take the silver trim off, I didn’t see you access any screws behind it once off? I have the same problem on my 2012 F11 but it’s the drivers side door.

Bravos. I will check if for me it's the same.

Great video! 1 question. What is that vertical bar on 4:36 min? (How) do you need to place this bar back to the right position?

How about the 2 front doors? Are you going to reseal them too?

I know this video is an old one, but in hindsight would you of just put a load of silicone sealant all around perimeter edges of foam insulation?? Steve

what if i got water inside the doors but not on the carpet? when i open the doors water leaking through the bottom whole (with a cap) in the doors (metal part of the doors) - is that ok or needs to be done something with it? Why there is water?

Hi there, having the same issue on my 525d SE. What diameter of butyl tape did you use? Thanks.

After removing the door panel a metal clip fell off. It's a U shaped thin metal flat retainer. I spent hours thinking where it might go and got no clue. Does anyone know where it should go?

How did you dry out the floor under the carpet?

Have the same problem on my f10, waiting for the adhesive to come.

This door leaks are known for about 20 years now. i had this problem in many bmw e39 cars. and it is still not fixed by bmw, after decads...very dissapointing from customer point of view.

Hi what the name of that tape? Thanks

What size tape did you use?

Are you sure you fixed it