I have Rons plan for this but there is no actual dimension for the drawer stop piece. Is it just supposed to be a touch smaller than the drawer bottom cutout.
I'm trying to better understand how this works. Is there enough 'play' top to bottom that when lifting the drawer, it can still slide over the stop then?
@@TheSmartWoodshop - I apologize as I'm pretty new to woodworking if this is obvious. Is there a picture anywhere that has a closeup of how the cabinet runs in the dado and works? I appreciate the response!
Hope you folks had a nice Christmas, Ron!. Although I'll probably never build a vehicle mounted shop I, like so many DIYers, have a shop that's constantly in a state of upgrading, remodeling, revamping, etc. and your entire smart workshop series is "gotta see" for this DIYer. Never a wasted few minutes nor a "dull" moment watching your contributions.
Hi Ron I keep forgetting to ask and I apologize if you've already mentioned it, but what happened with the two tool boxes you we're going to use and what made you decide against using them? Thanks
Hey Ron, nice passive stop. I didn't notice you had a way to keep the drawer from being accidentally pulled out all the way. Have you had any issues with that?