C8 Z51 Corvette Detail & Ceramic Coating 

I do too

I agree, it would be nice if you could show us what products you are using.

This was the first one I actually drove other than pulling them in and out of the shop. I was impressed!! Thanks for watching!

A Z-06 2-hp more less torque for that extra cash I do not see much value. Maybe bragging wrights.

I'm with you 100% on that!!

Thanks! Any specific kind or brand that your recommend?

Thanks!

I believe I used 3D One with an orange Lake Country HDO polishing pad.

Hey, Thanks for watching. I haven't had any issues with the Quickjacks since I bought them. I don't use them on a daily or weekly basis, but they have definitely come in handy on a number of jobs. If you have the wall room, get the hangers so you can neatly store them in your shop or garage. Other than that, the only other items that I bought were the stakcable truck adapter kit Make sure if they are stored for a long period of time you take them out and use them. I found out hard way that the seals will go bad and you'll start leaking fluid. So far I only had to replace one quick disconnect on one of the lines

@@JsAutoDetailing thank you for the response. I’m going to order them and will get the wall mounts and the stackable truck adapters. Much appreciated

I've done a few engine bays in my videos Thanks for watching!!

I applied Jade Graphene ceramic coating. Super easy to use and apply. Flash time will vary depending on temperature/humidity. I was waiting about one minute before wiping during this application. I've been using the Jade line of coating for just about 6 years now. Great products and great results.

Hardline Products RS-00001 Rollastand for Sport Bikes, Red www.amazon.com/dp/B000GU0XRO/ref=cm_sw_r_apanp_ijNtbJd4QUIxo

Thanks for watching! I got roller stand on Amazon. There are other versions out there that hold the wheel steadier, but this is a cheap alternative.

@@JsAutoDetailing Thank you so much! - Also, what was the product you used on the buffer to “Correct” the paint?

@@illiyakuryakin3092 I used 3D One on a Lake Country HDO polishing pad

@@JsAutoDetailing Thank you very much again!

This was a used car. I polished the paint to prep it for ceramic coating. There were some small imperfections that needed to be addressed.