Thanks! Their were some parts I should have recorded but didn’t realize it until editing. By that time the project was done! Taking that lesson into the next video lol
@@deonbaptiste1991 Its hard to say with artistic pieces like that but I value it at $800.00 having spent a considerable amount of time effort and resources on it.
this is awesome. i’m looking to get one of these machines. so can you pause the cutting and resume later. if the power goes out. or you need to have it be quiet at nighttime?
Thanks! You can pause the machine for extended periods of time but if you turn it off it will completely reset your project. I frequently pause the machine and than come back to it 8 hours later or so and haven’t had any issues with that.
Looks amazing, great job! How's the wall installation working out for you? Do you find it difficult to mount materials? I'm so tight for space in my workshop.
@@rirsz so it does work with lighter workpieces but not with heavier ones. I had to much trouble with the tape and glue method on the wall mount so I stopped doing it entirely.
How did you pause during the finishing pass? I didn't realize that the Buildbotics sofware would let you pause and pick back up where you left off. Beautiful piece BTW.
I paused it and left the box running so that it wouldn’t reset to the beginning. I think their is a way to edit the G Code to break it up into time blocks but I haven’t learned how to do that yet!
how do you load something to thumb drive and then to machine? I just got my foreman set up( first cnc) and did elite test cut but cannot figure out how to add something else. Any help, please.
Congratulations, that’s a nice one! I believe the foreman has a Wi-Fi connection you will need to connect it to your home network and than read the address displayed on the top right of the foreman screen. Enter the address into a web browser and you will see the admin screen on your computer. From their you can upload files directly from the computer to the foreman. If you want to use a thumb drive you must use your computer software (carveco, vCarve etc.) to produce the gcode from your created tool paths. After that transfer the Gcode from your computer to the thumb drive. Than take your thumb drive out and plug it into the usb on the foreman - you than can load the new gcode onto the foreman from the admin screen. I separate my toolpaths into separate files so I can run them independently it might be helpful to number them in the order you will carve them. Hope this helps!
Mechanically it works just fine! I have the QCW frame from 1F as well which helps a lot. Sometimes it can be difficult to clamp down heavier workpieces with gravity working against you.
You can find a lot of 3D files on Etsy that are like this one. The size will depend on how you manipulate the STL file in your software. IE CarveCo / Vcarve