Sweep needs adjustments. It's dangerously close to the pin deck in the 5 pin area. A quick adjustment is to manually advance the cycle forward from the 180 position until the sweep is at its lowest point around the 5 pin area. Adjust the sweep arms until you can stand a 9 1/6 end wrench on end under the sweep. It's a quick fix and beats measuring everything to spec. So many times we were so busy that we put two people on it and it only takes a couple of minutes.
@@EddieAndElwood I was up at an alley in Chandler AZ where the rake on lane 12 made a noise that could only be compared to fingernails across the blackboard!!! Ironically, the place is called AMF lanes with 32 lanes of A-2 Brunswicks. I will say that other than a few problems like that, their machines ran better than ours did in Tucson! I was there for HOURS and didn't see one call. No stuck balls, OORs pins blown out into the gutters!
@@keithchrysler3732 one time I was either bowling league or open bowling but, I’m pretty sure the deck went down, while the rake was trying to sweep so they were both going at the same time. It sounded like me screaming lol