Steve it cut off - was there more. I saw the control box installed toward the front. Was that it? Is this for 1181N? Needle Positioner available? Are there settings to lower the speed of the motor. Thanks
Bro, I swear, I'm one of your biggest fans. All your videos are amazing, but this one is a deep fake. The title completely inaccurate dude. You simply show how to install (fasten) the motor to the table base. You do not show the brushless servo motor setup. There is absolutely nothing regarding the servo motor setup!! Nothing electronic. The video is very unprofessional. It just cuts off like your battery died or something. Swr4him asked 7 months ago and still no reply? I used to look up to you man. I was even going to buy from you because your videos, but your store didn't even have c3000 and I had to buy from amazon. I hate to go through a large corporation, but you left me no choice bro. You are falling off man tighten up. Please edit the title or vides, or take it down entirely. Tighten up bro. Please.
