Cutting EVA foam decking

Подписаться 392

Просмотров 5 тыс.

50% 1

I get asked a lot about cutting EVA or PE foam boat flooring, so here is a rough vid of our process and the bits used. Sorry for the noise at 9:43 min in, we had to run the vacuum pump for another project.
Hope this info helps those who need it.
Links to bits;
Ogee - www.amazon.com/Ogee-Groove-Ro...
Round Over - www.amazon.com/Whiteside-Rout...
Drag Knife - donektools.com/

Наука

Опубликовано:

25 июл 2023

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@engina1572 2 месяца назад

Wow thanks so much for helping out and showing the process. I am about to attempt my boats floor here soon.

@jasonbowlin9168 3 месяца назад

Great results! I run some smaller stuff on my CNC but I run at 24k rpms and 300-350 IPM....get very good results as well. Maybe something you could try.

@Dan-un4jy 3 месяца назад

Had to filter through all the useless EVA videos to finally find this one. You have the CAD, tooling info with speed & feed data, the tools, and the cuts. Great job. Informative, succinct, by the numbers video that has a wealth of 'how to'. This should be the go to video for anyone looking for the basics in CNC cutting EVA foam flooring. Thanks!! Getting ready to cut carpet on a 29' Twin Vee and an 18' flats boat. Question: Was this tape with vacuum hold down or just taped? I'm using stick on backed EVA. Are there any issues with cutting EVA using a vacuum hold down?

@bordesigns1429 2 месяца назад

This is with a vac hold down, we also tape the edges as the material isn't always flat.

@taylorspears5790 3 месяца назад

How did you manage to get an endmill tool to set to 0 RPM? Vectric prevents this now.

@bojangles5226 2 месяца назад

edit the gcode.

@fabiantorres23 2 месяца назад

Where do you buy the raw material?

@bordesigns1429 2 месяца назад

There are a lot of sites on line, Amazon especially. However SeaDek has updated their online store and have more options directly available than they did a year ago. Would recommend them.