The video tells the solution of fiber laser cutting, cypcut NETWORK TIMEOUT ALARM. The basic steps are listed in the video.
Our Store/Nuestra Tienda: www.spierlaser....
Contact: Clara@spierlaser.com +86-13335151833
Hi, I am Clara. It is summer day here in China, very hot, hoping you guys enjoying your days, summer or winter. Today we are going to tell you the solution for NETWORK TIMEOUT ALARM, it is almost a teaching video, so please don’t miss it. Before get into the main chapter, please don’t forget to subscribe to this channel and give me your like, thank you.
The control system in today’s topic is the Cypcut, so as the height controller. So please take the video as your solution if your system is not CypCut.
If there is such alarm appearing in the PC--NETWORK TIMEOUT ALARM, it occurs because of the IP address. Normally we need to connect the industrial PC by two ports, one is to the laser source, the other is the height controller. The laser's network connection will not be our topic today. First of all, we need to make sure that the two network cables are connected very firmly, because loose cables can also cause such alarms.
If we rule out the loose wire as the cause, we need to determine which local connections the height controller corresponds to,. As we said just now, two connections only, one for laser source, one for height controller. Generally speaking, the colors of the two network cables will be different, gray one is for laser source and yellow for height controller. Here the colors are not fixed forever, probably yours will be different, it depends on the actual condition.
Here we need to observe the feedback in the computer while operating. We first find the network settings, in the properties, find the Ethernet, where local connection 1 and local connection 2 will be displayed. We try to unplug the yellow network cable to see which connection disappears, which means that the yellow cable corresponds to the number of local connections. Then re-plug the Internet cable (we also need to make sure that there is a flashing light at the connection, which proves that it is working normally), find the corresponding local connection, double-click, find Protocol 4, Properties, and enter the following addresses in sequence:
10.1.1.100（The last must be less than 200, but not 188）
255.0.0.0
10.0.0.1
After finishing the step, we need to operate on the height controller panel, press F2 and then press 6 to check the network settings of the height controller, and make sure the network setting is "on". If we have modified the IP address here, it is necessary to restart the height controller to take them effect. The IP address of the height controller is:
10.1.1.188
255.0.0.0
10.0.0.1
Then we need to go to the Machine Config Tool, find the height controller, and check whether its address is 10.1.1.188. If all above steps are finished, we can click “Test Connection”, and the alarm should be gone, then our solution is successful, and the problem has been solved. If it is failed, we need to repeat the above steps. Or we can try to change the IP address of the Ethernet in the computer to be obtained automatically, and then set it in the Machine Config Tool and then test the network.
This is all we have today, hoping you have a happy time with me. Over here is my contact information, please tell me if you need consumables, laser source or other components of the laser cutting machine. What do you want to know? Please write it in the comment below, I’d like to make a video for you. Thank you for joining me here today, I will see you next Tuesday here on my RU-vid channel, see you, bye!
25 авг 2024
