Great video! Very good explanations and tutorial. Just what I was looking for ,just got my Motor Guide XI3 in for my Titan X for next season. Thanks again. What length shaft is that on your Motor Guide?
Thanks for a great video. I'm planning on an xi3 on my Crescent Shoalie and I like your idea with the bungee. I had a pa14 with an xi3 and had to reach up and push it out to deploy. Only question I have is how do you get it to turn to stow? Every time I tried to stow the one on the hobie it would turn the motor down and prop up and I had to again reach up and manually turn it so it would stow. What was I doing wrong? Thanks
Love the video man. Excellent ideas. I am installing an Xi3 on my kayak and will be using the bungee cord and dual handle ideas for sure. My question is why did you go with the bonafide plate vs the one objective? I keep going back and forth and which one to get. Would love your opinion.
One objective has a really great trolling motor mount, but where it comes back it screws into the screw inserts which to me just isn’t enough. The Bonafide plate you actually do drill a hole and insert a small backing spacer that adds security to me. They are both great options.
Thanks for this video and the very clear instructions. I love your deploy setup - especially how clean and tight the cable is so that it’s never in the way of your feet. I’ve tried to do this several different ways on top of the deck and it’s never not in the way. How did you get it to be the perfect length to make the handle always stay tight against the kayak?
Thank you. Tie the cord to the handle first pull it to the trolling motor and where it ties on to the carabiner just make it about a 1/2” shorter than what you want it to be before u tie it on.
My problem is a lot of times when pulling the motor up to stow it, it turns different ways. Most of the time its nose up so I have to re-deploy it and keep pulling it back up until it sits right. I'm guessing the clamp you are using fixes that, or do you run into that at all?
Yes the clamp helps with that. We all have the problem of the motor wanting to roll around and not come up to stow properly. Having the clamp to pull the motor up sideways is the trick to help with that.
The bicycle seat clamp just below the Motor Guide head is meant to be tight and not allowed to spin on the shaft per say? Some of the other installs that I have seen have a Pan-Optics 2-piece collar on there and it is not tightend and it is allowed to spin with the rope. I ordered the same bike clamp you used so I will try that out first. I am thinking that it should be not allowed to spin like your set-up as the motor head has to rotate and lay on its side when fully protracted and lying in the home position. Sorry for the long drawn-out question.
i love your videos. i would like to thank you. I just wanted to let you know that the emage quality of the videos is quite bad. Your videos are uploading at 480p - RU-vid gihest quality was 480p in 2008, perhaps a better camera or diffrent upload process at a higher video resolution. Your outlaw videos have been amazing. Thank you ones again.
Thank you, the videos are in 1080p I use a GoPro hero10 and a iPhone 14pro max for videos. That’s the highest quality RU-vid will allow me to upload. Now that you mentioned it I went in and looked and yes it’s in 480p that’s all they’ll allow.
@@334tacticaloutdoors I wonder why. there has to be a way as most of the videos i see now days are at 4k, Ether way..keep up the videos. thank you so much.
I put the pipe through the hole then heated the ends with cigarette lighter then pressed the ends with a wood block. It doesn’t take much to get the ends to flare.