Hello! I had the parts left over and I know the DDS is no longer available. If I did this all over again, I would buy the Bondtech DDX for CR-10S. The DDS doesn't have a lot of clearance at the bottom to see what's going on while the DDX is much better. Start with that (www.bondtech.se/product/bondtech-ddx-v3-for-creality-ender-cr-10s/) and scroll down to "The 4 PHases of DDX" If it were me, I would go PH3 with the full Copperhead or Mosquito. (Probably Mosquito since it's so easy to change nozzles out with!) You would need a CR-10/Ender carriage (www.tinymachines3d.com/products/creality-x-carriage) and then you're off. The real challenge, which is where I am stuck, would be the firmware. I don't have that creative gene and am relying on someone to give me a hand with that! I hope this helps? Let me know !
Working on my E3D V6 upgrade today with dual 24v parts fans on my Eryone V2. You had mentioned moving the jumper to supply cooling fan with 24v. My jumper is labled 5v/24v/12v with the jumper on the 5v/24v posts. I Am assuming the jumper moved to the 24v/12v posts will supply the fans with the needed 24v? I am also assuming you were using stock motherboard?
Yes you can search the Eryone forum to see a board layout. Leave the board fan on place thou, that’s on its own 5V source. Also of you are using a Bondtech make sure you adjust the e0 stepper driver. Remember you need to do some math for 2208 drivers