Discovery 3 Hitachi Air Compressor teardown

Подписаться 24 тыс.

Просмотров 36 тыс.

50% 1

Teardown of a failed Hitachi air suspension compressor from a Land Rover Discovery 3.
- - - - - - - - - - - -
Due to factors beyond the control of FixItSam, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. FixItSam assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. FixItSam recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of FixItSam, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not / fixitsam .

Авто/Мото

Опубликовано:

4 июн 2019

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 24

@benatherton5355 4 года назад

Many thanks for the insight into the Hitachi compressor. Very handy vid when learning about LR's.

@tonyr1963 4 года назад

Thank you for the video. I’m new to LR air systems so I’ve found it very informative and helpful. Cheers

@leehowdle5051 4 года назад

This was a fascinating video, I think the lesson here is buy a new one and then see if you can service your old one as a spare for later

@jshoe1986 2 года назад

Lay of the impact drivers dude 🤣🤣🤣👍😀

@Discoworx 4 года назад

Good video, thanks. I usually lube up rusty bolts and hit with a hammer and use hand tools if it looks bad to avoid stripping heads.

@fly101 4 года назад

Nice video i am definitely going to have to take mine apart now and chech the dissident thank you

@Christian76S 5 месяцев назад

No penetrating lubricant and powertools. Wonderful.

@dixiedean1955 Год назад

Cheers, very informative. Mine needs servicing, but I'm not holding down much hope of it being any better than yours.

@michelbonnet3787 Год назад

Hi ! And thank you for this video. On my D4, I've an Hitachi compressor that I want to replace by an AMK, cause I've bought a new one before knowing they were not "plug and play"... What are the modifications to do in the piping and what I will need to do ? The secondary plug shows only 4 wires (6 for Hitachi). Does it matters, supposing having to replace the firmware (with my GAP tool) ? Thanks in advance for your precious help. Michel

@manibanai5137 Год назад

Hi.what did you use under piston.oil?in shaton

@442Carew 11 месяцев назад

a little bolt free spray may have helped

@alanottley 4 года назад

Great video - thanks!

@jameshalford4699 Год назад

Where do you get replacement filters from please

@kevwilliam 4 года назад

Great video but if you had used an spray oil like wd40 or rust breaker you might not of had so many bolts shear off on you but then again the parts come off a landrover so it’s surprisingly hasn’t fell apart before you took it off 🤣🤣🤣 I’ve got to take my air dryer apart as my compressor’s struggling just lately 😔 Wish me luck as I use mine off road lots so it’s always in the thick gloopy mud and water 🤣🤣🤣

@kaibintech 2 года назад

Nice!

@MrJnr786 Год назад

Any chance I can buy the dryer filter unit ?

@NHEFF09 3 года назад

Talk about heavy handed

@stuarth43 4 месяца назад

there is another bloke that calls a screw, a bolt

@ned900 3 года назад

what a horrible peice of metal. I was thinking about replacing my P38 pump with one of those that I found used, but seeing this, no way! | The P38 pump came apart no problem, its a Dunlop, I wonder are they better metal. Nice to hear an Irish accent.

@DiscoGruffalo 4 года назад

What you think is the exhaust valve pipe is the crank case breather pipe. What you're not exactly sure is what, is the exhaust valve. What you think is the exhaust valve is the delivery valve.

@FixitSam 4 года назад

Cheers Russ!

@danwilderspin1984 3 года назад

@@FixitSam would you sell me your old motor? In the uk let me know if so

@UptownFights 3 месяца назад

So I bought a cheap ebay compressor and it pumps up good, but psi bleeds of in like 5 seconds when it turns off. I have parts compressor that ring is warn? Is that exhaust valve my culprit? Think I could just swap it into the ebay one? I would like to know where the one way check valve is to hold pressure into the dryer side.