Тёмный

DIY:2007 Tacoma w/ Compustar Q9 alarm-remote start installation. 

FlipSide Garage
Подписаться 3,8 тыс.
Просмотров 2,1 тыс.
50% 1

Опубликовано:

 

8 сен 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 21   
@timfrancis6774
@timfrancis6774 Месяц назад
how do you remove an old one that died? it has stranded me for years. i can see brain but its behind radio, have to take out radio anyway. cause it no longer works truck looks like disaster please help
@FlipSideGarage
@FlipSideGarage Месяц назад
Pretty much just follow all wires they tapped into and make sure use tape and secure all wires from vehicle side
@timfrancis6774
@timfrancis6774 Месяц назад
@FlipSideGarage would it be ok to send pictures, cause I can see big black box but can't remove it cause jammed in behind vent
@FlipSideGarage
@FlipSideGarage Месяц назад
@@timfrancis6774 have to figire out a way to remove the box first and trace all wires..wont be to bad
@timfrancis6774
@timfrancis6774 Месяц назад
@FlipSideGarage have to remove entire center section including shifter know cause replacing usb and adding one more
@timfrancis6774
@timfrancis6774 Месяц назад
What a pain that was, took 8 hours and then zip tied it behind speedometer, have pics if want to see them
@reesef6030
@reesef6030 8 месяцев назад
I have a manual so I don't need to bypass mobilizer for remote start. What would be total time for your install without that? Pretty sure my 2008 is the same more or less? Let me know?
@FlipSideGarage
@FlipSideGarage 8 месяцев назад
Immobilizer applies to both auto or manual trans. Time depends on your experience
@josequintanilla1813
@josequintanilla1813 11 месяцев назад
Hey broth , where can i get it all programmed like the one you installed, i have a 2007 Tacoma as well, thanks..
@FlipSideGarage
@FlipSideGarage 11 месяцев назад
Installed or program a remote?
@mazdavnshopnhatrang
@mazdavnshopnhatrang 10 месяцев назад
Hello. Where do you buy the ads blade hardness 20 pin
@FlipSideGarage
@FlipSideGarage 10 месяцев назад
Yours didnt come with one?
@xavi-12
@xavi-12 6 месяцев назад
Hey bro how can I get in contact with you. I need an advice… look like my pilot just crank and I can make run. It just run if I put the key in the cylinder. Other than that just crank. I put a remote viper and idatalink module. Please and tanks in advance
@FlipSideGarage
@FlipSideGarage 6 месяцев назад
What's up?
@user-ov8jj9yq5e
@user-ov8jj9yq5e Год назад
What do you use to remove wire jacket on harness ? Thanks
@FlipSideGarage
@FlipSideGarage Год назад
To strip it? Or fully expose the copper wire?
@user-ov8jj9yq5e
@user-ov8jj9yq5e Год назад
@@FlipSideGarage expose the copper wire on vehicle factory harness
@FlipSideGarage
@FlipSideGarage Год назад
@@user-ov8jj9yq5e I use an automatic stripper. If a wire is to thick. I use a blade
Далее
How to spend $2,350 on a $400 remote car starter
27:41
🎙А не СПЕТЬ ли мне ПЕСНЮ?🍂
3:04:50
кого отпустят гулять чееек
00:53
RARE EONON #MAZDASPEED3 - FULL INSTALL 2024
13:04
Просмотров 1,6 тыс.
Toyota Tacoma Remote Start Install | Start X Kit
15:57
🎙А не СПЕТЬ ли мне ПЕСНЮ?🍂
3:04:50