Linktree to the tools that I use and my other socials:
linktr.ee/buil...
Check out my Etsy Store!
skatethencreat...
Music: Skate
Artist: Jef
This video shows how I made a Skate box and Manual pad fit into my Hatchback! I wanted to make this video to show that you don't need your own warehouse or a large van or SUV (or even a car) to be able to have your own mini skatepark.
UPDATE: If you are using an angle grinder to cut the coping, I recommend getting a 40 grit flap disc for the angle grinder to round the edge of the coping that you will be skating on. After skating it for a few months, I noticed my trucks were wearing down a lot faster than normal, due to the sharp edge of the coping/steel angle.
Music: Skate
Artist: Jef
Tools and Materials are below:
Ryobi power drill:
www.homedepot....
Ryobi Circular saw:
www.homedepot....
The angle grinder I used is several years old. But most home centers have a wide selection:
(If possible, make a box that is 6 ft or 8 ft long to avoid needing to use an angle grinder and just buy steel angles already cut at 6 ft or 8 ft.)
www.homedepot....
You can also rent tools at Home Depot (Also check your local home center to see if they rent tools out if you dont have a Home Depot near you):
www.homedepot....
I used a 12-inch rafter square (but you can also get smaller ones for cheaper):
www.homedepot....
I used heavier duty clamps but you can use much cheaper clamps for cutting plywood:
(A couple of 12 inch clamps should be fine, and maybe one 24 inch or a 36 inch clamp to hold the larger pieces.)
www.homedepot....
www.homedepot....
www.homedepot....
www.homedepot....
I used this T-Square (though you can use practically anything to guide your circular saw as long as it's straight):
www.homedepot....
You can use this trim square to help you cut 2x4s to length:
www.homedepot....
Metal countersink drill bit:
www.homedepot....
2x4 Douglas Fir:
www.homedepot....
23/32 plywood (for the walls of the skate box) :
www.homedepot....
15/32 plywood (for the top):
www.homedepot....
Masonite 4x8 sheet (tempered hardboard):
www.homedepot....
Masonite (2x4 sheet):
www.homedepot....
2 in. x 72 in. Angle Plain Steel with 0.125 Thick (Coping for skate box, which was cut to 60 inches with an angle grinder):
www.homedepot....
I used 2.5-inch coarse Drywall screws (DONT FORGET TO PREDRILL YOUR HOLES (1/8th inch drill bit should be good.):
www.homedepot....
Cheaper, decent furniture dolly:
www.homedepot....
Better quality furniture dolly:
www.uline.com/...
You could also potentially make your own using scrap 2x4s and buy some 4 inch casters
www.homedepot....
Comment down below if you have any questions!
Jukin Media Verified
Interested in licensing this footage?
Learn more @ www.jukinmedia...
11 сен 2024
