Eight Essential Tormek Maintenance Tips

Подписаться 37 тыс.

Просмотров 7 тыс.

50% 1

Tormek makes extremely robust and long-lasting sharpening machines. However, if you want to get the most out of your Tormek, here's some essential maintenance that needs doing.
Tormek Sharpeners
www.sharpeningsupplies.com/To...
Chapters
00:00 Introduction
00:10 Refresh the Grindstone Surface
00:46 True the Grindstone
01:42 Lower the Water Trough
02:04 Clean the Water Trough
02:30 Use a Dust Cover
02:56 Refresh the Drive Wheel
03:56 Sand Leather Honing Wheel
04:31 Grease Bearings and Drive Shaft
05:09 Conclusion
05:32 Bloopers

Хобби

Опубликовано:

25 июн 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 16

@Gman1024 Год назад

Must save video for anyone with a tormek, great info.

@SharpeningSupplies Год назад

Thanks! Glad I did this video, I'm greasing my bearings now!

@mcooper320 6 месяцев назад

Great Video!! Thanks.

@kens4741 Год назад

A turkey baster is an inexpensive, handy way to drain the water from your water trough. No spillage. When you are down to the sludge, use a paper towel. Give a final rinse with clean water keep your water trough like new.

@SharpeningSupplies Год назад

Fantastic tip!

@billrogers6863 Год назад

Tip 7 - you might get the bump on the leather wheel if you have a build-up of honing compound in one (or more) spot/s.

@SharpeningSupplies 11 месяцев назад

Good tip.

@mitch3384 5 месяцев назад

Make sure you clean off all the lubricant on the stone side where the driveshaft comes through. I left it messy when I did mine, and over time the white grease spread all over the inside and outside of the SG-250. Luckily not the actual grinding surface.

@SharpeningSupplies 5 месяцев назад

Good tip!

@hapapa 8 месяцев назад

I have a tormek t4 bush craft. I've noticed a loud noise. Any advice on how to fix that? It only happened when i would apply pressure with my knife, but now it makes that noise all the time. I tried cleaning and re-greasing, but that didn't work. Any advice would be helpful. Thanks.

@crztrn1 9 месяцев назад

what was the truing stone for

@SharpeningSupplies 9 месяцев назад

The truing tool levels the surface of the grindstone.

@lassevejbymadsen9288 8 месяцев назад

No it’s for changing grit on the sg-250 stone

@SharpeningSupplies 7 месяцев назад

@@lassevejbymadsen9288 Good point, there are two different things, the Truing Tool levels the grindstone surface, while the Stone Grader can refresh the grindstone surface and make the effective grit coarser or finer.