MY WIFE INSTALLED THIS ON HER OWN BY THE WAY.. this video was simply made as an instructional video shoot requested we make because of the influx of these devices being sick after and purchased. Therefore please do not criticize, no is not our normal content, but times are different and she wanted to make this known. Thank you for watching
WHAT IS AN EMP SHIELD? WHAT DOES IT DO? Here’s what it does!
EMP Shield is a family of incredibly robust EMP, solar flare, and lightning defense technologies.
They have been designed to exceed the US Military requirements for protection against a high-altitude nuclear detonation that results in an electromagnetic pulse. This family of products has been tested at Keystone Compliance, a DOD Certified Testing Laboratory, to verify compliance with the following Military Standards:
MIL-STD-461-RS105 Transient electromagnetic pulse of up to 50 kV/m, double exponential wave with a rise time in the nanosecond range, that is applied to the equipment under test (EUT) at least 5 times. We tested at 50 kV/m and also 90 kV/m (80% above required testing voltage).
MIL-STD-188-125-1 High Altitude EMP
MIL-STD-461G Control of Electromagnetic Interference
MIL-STD-461-CS-115 The purpose of CS115 is to test an electronic or electrical system to withstand signals coupled onto the test unit’s associated cabling. The test unit will be subjected to rise and fall times, pulse width, and amplitude as specified on Figure CS115-1 at a 30 Hz rate for one minute;
MIL-STD-461-CS116 applies to 10 kHz to 100 MHz for all interconnecting cables, including power cables, and individual high side power leads;
MIL-STD-461 CS117 apples to all safety-critical equipment interconnecting cables and non-safety critical equipment with interconnecting cables/electrical interfaces that are part of or connected to equipment performing safety critical functions. The goal is to test the unit’s ability to withstand lightning transients coupled onto the test unit’s associated cables and power leads;
MIL-STD-464C Electromagnetic Environmental Effects Requirements for Systems.
Our test results show that we begin shunting the over-voltage condition in less than 1 nanosecond, and our units are designed to shunt over 100,000 Amps per phase. Our devices are scalable to any size.
Summary of capabilities:
Features:
Quick acting HEMP surge protection that switches in less than 500 trillionths of a second.
High current shunting capability above 100kAmps.
Exceeds MIL-STD-188-125-1, MIL-STD-464C, and MIL-STD-461G requirements.
Units are designed to protect power, control, data, communications, and radio antenna input.
Made to support:
Models available for all Single & 3-Phase Power configurations
Models available for all DC Voltages
Models available for Data, Ethernet, RS-485, RS-422, RS-232, Etc.
Models available for RF Communications, Antennas, coax, Etc
This EMP shield was Amazing and simple to install!! No more worries about those BMPs around my car! Bravo to the wife for installing this herself! She’s a do it yourselfer! or so you could say! Thanks for watching guys, this isn’t your typical Paintless dent repair video but I thought this was important to bring to light since this item has become seemingly more and more important, as weird as well have one. That being said I would all wanted to show how simple and not scary it is to install this amazing amazing, by the way used by her very own military for securing against EMP threats, This EMP shield is worth it’s weight in gold! And NOOOO!
we are not sponsored by this video at all whatsoever, My wife simply wanted to make it a video so the others who might be nervous about the insulation could breathe easier seeing how easy it is! If you’re interested in these, you can visit
www.EMPshield.com
there are discounts to be found!!
21 сен 2020
