No está mal si no tienes medios, ese trabajo es mejor con una prensa hidráulica de esa manera se estiran las roscas del bloque, otro apunte al momento de introducir la camisa nueva cúbrala con aceite eso facilita la instalación.
Привет из России рисковоно так прессовать. Я на своём грузовике делал ток гильзы цылиндров ложыл в морозильную камеру в пакетиках чтобы пылинки не попало. А посадочное место в блоке прочистил так чтобы и волоска не было. А блок двигателя слегка горелкой подогрел и по очереди вытаскивал гильзы из морозилки и руками вставлял в блок целиндров. Гильза целиндров была 2мм и диаметром 126мм в руках жималась. Таким оброзом гильзы легко вставляются в блок лижбы не было ни пылинки и волосков. При усилином пресований образуется микро надирчики между гильзой и блоком целиндров. В тех местах гильзу отжымает в сторону поршня происходит зажим поршневой. Желаю удачи в делах и здоровья вам.🖐🤝
Вот благодаря таким рабочим людям, цивилизация ещё существует. Когда у вас что то сломается, менеджер или юрист Вам не помогут. Они даже толчок свой не починят.
Если нагреть блок до ста градусов (Той же водой) ,а гильзу охладить Углекислогой из баллона ,то это был бы тот минимум когда все́ на. Отлично. А так всё на троечку.
@@j.cesarbraga I think if I was running a business rebuilding engines I would have a freezer large enough to cope with the demand. It not just liners, it's also helpful when fitting bearings or shafts. It can save a lot of time, and potentially stop parts from being damaged.
Bacana tem um amigo aqui em Brasília que tinha um 1113 e precisou trocar 1 camisa o mecânico que fica na cidade satélite de Candangolândia faz esse processo, bem o meu amigo fez e rodou com o 1113 por mais de 5 anos, vendeu e o caminhão ainda rodando sem problema
É só empurrar um chave de fenda grande, ponta amolada (melhor sem o cabo) entre a camisa e o bloco (tbm pode ser talhadeira fina bem amolada). Começa beliscando pra ñ danificar a superfície. Alguns casos, faz de baixo pra cima!
Looks like a very time-consuming job just like the guy says put it in the freezer they're going faster wish I could do some wrench in myself need more videos like this😊
IQ of the same thing to say I used to freeze the sleeves and inside of the cly. with oil and a little oil on the sleep before I put it in you're not supposed to put them in dry the oil helps transfer the heat and the sleeves will pop right in. Especially if you clean up the cylinder bore of the engine block.
Não precisa esse trabalho todo é só congelar as camisas e colocar com as mãos sem precisar de ajuda de um macaco ou prensa e com isso ganhar tempo que é oro tá aí minha dica e um forte abraço.