Great video, just put a new clutch kit in my peugeot 3008 2011. Replaced the slave cylinder so I assume I have to bleed the system, will this diagnostic tool do it?
Hi mate I’m hoping you can help I really just had my clutch actuator changed in my 2012 citron c3 everything was working fine until I drove home one night parked the car either the gear in R, the next day I tried to start the car it wouldn’t start, I looked on the dash and it’s not showing anything just a - where the gear supposed to show, the small screen on the dash kept saying out car into N and press the break I put it in N and pressed the break but it won’t start, someone advised me to get a new battery I’ve done that but still no luck, the gear box is in N but somehow the car won’t roll seems as tho it’s still locked in R from when I parked it that night can’t get it toed either as they want more money because the car won’t roll any advise on how I could sort this out or at least free the locked gear so it can be rolled?
Hello I have changed an actuator on a Peugeot 208 2014 diesel. When I go into the settings to programme the actuator using my Maxidas ds808 tool the programming fails. This is what I get even with the battery charge above 12.5 v and connected to jumper Programming failed Ensure that the vehicle battery is charged -If a battery charger is connected to the -vehicle battery Connect a battery of a second vehicle with its Engine running in parallel -Restart programming -Read the fault if another fault is present The only other fault present is in the bsi unit P1A9C permanent fault …energy Accumulator state of health ( SOH) Fault of energy accumulator I cannot seem to get past the battery issue problem to continue the programming. Can you help ?