Ford Barra Territory Oil & Filter Service Change 

may i suggest next time using some disposable nitrile gloves and you definetly need a low profile oil drain pan...one more thing i use a big piece of cardboard that a tv was boxed in and slide that under will be more comfy to work instead of concrete and will absorb the oil spills.... Cheers for the vid!

God i near want to cry after watching this. Yea well some suggestions. If you are going to do the filter change from under the car reverse, it up the driveway and then put down 2 blocks of wood at least 5cm high but 10cm would be good in front of the front wheels and drive up on them to raise the front. Then CHOCK the back wheels. It will give you more room and get the car a bit more level for refilling the oil. Put down a small plastic tarp as you are messy :) If you do not want to go to that trouble well you can just remove the air box as the filter can be accessed by there so you can change it from up top ;) Still put down plastic. When you use the spanner flip it around, so it is angled under the sump more than out from the sump. They hold on better. Think you need a new sump plug too. Last thing is if that Auto oil cooler on the side of the block has not been changed do it ASAP. They fail and destroy your gearbox. First thing always changed on a auto ford 6 or 8. Putting a after market one on that goes in front of the radiator is best from Repco or Autobarn. If not just replace it with a genuine ford one. Do not use after market ones on ebay.

Thanks you for the feedback. Appreciate it. I will take all that on board and anyone watching please do the same 🙏