Ford Power Steering (ThompsonBox)

Подписаться 1,3 тыс.

Просмотров 115 тыс.

50% 1

Repair on a 1970's Ford Power Steering Unit/Box (Thompson Style). Power Steering Fluid leaking at one of the O-rings that seals the housing. Power Steering Unit still power assisted, only had external leak on housing seals. Went MANY years with small leak, and finally needed full repair. This repair was done in 2010.

Опубликовано:

5 май 2011

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 10

@camoreno302 7 лет назад

this video is more about the tools he fabricated to do the rebuild than the actual rebuild. an actual rebuild video of this particular gear box would of been great.

@ZebulonTurrentine 3 года назад

I had a similar issue with a 95 Pathfinder steering gear box. I ended up drilling a couple holes into the lock ring for the more readily available Face Spanner Wrenches.

@williamscott3741 11 месяцев назад

That was a good film. How how many ballparians went into that warm Gear.

@tristanbinder2497 8 лет назад

How many ball bearings did you have? I'm currently trying to rebuild the same box. Also, how do we take the worm gear stem out of the housing?

@wi11y1960 9 лет назад

There is a tool premade for autos if some one wanted to buy it. Go to a auto parts store and look for either a tie rod tool (with four pins) or some 4 wheel drives use a similar wrench. Either of those will allow some one to use either a impact wrench or a regular ratchet to unwind the retaining collar.

@Takunrsx 10 лет назад

it has 2 rings cause 1 its a regular oring, and the other one its a Teflon seal

@williamscott3741 11 месяцев назад

If anyone is still following this RU-vid site would you please comment on how many 5 sixteenths ball variants there? Was I stumbled in with this accidentally.? Ol boy...

@handyaf8061 3 года назад

My guess is that he did not need the fabricated pipe tool if he would have backed out the set screw first then used his screw driver to back the nut out.

@ricecarkiller 10 лет назад

what was the part number for the upper bearing its a bitch to find

@ricecarkiller 10 лет назад

MobileProductions21 thanks for the reply back .. I wish I could reuse my old one but the bearing cage/race is cracked and can not use it as it is .. well I'll keep looking