Foxbody Dakota Digital Install

Подписаться 677

Просмотров 3,4 тыс.

50% 1

Install of Dakota Digital RTX dash at Anderson Ford Motorsports using the Newrad Solutions Digital EZ harness installation kit. 1987 Mustang GT Foxbody.

Авто/Мото

Опубликовано:

20 июн 2023

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 15

@warrenkwilson 22 дня назад

Very useful video, I did the exact install on my 88 Coupe following the video instructions.

@k.c.williams3385 11 месяцев назад

I'm sharing this video with everyone I know.

@CarsFoodWeed 11 месяцев назад

looks cool. just fixed my speedometer cable on my stock gauges. next time it breaks I'll probably look into a modern solution.

@MrStangdawg 11 месяцев назад

That's what's nice about the digital dash, no more speedometer cable.

@BigJay916 11 месяцев назад

Excellent fellas!! 🎉🎉🎉

@MrStangdawg 11 месяцев назад

Thanks so much!

@Baddeal 2 месяца назад

I’m running a one wire alternator so the resistor wouldn’t be needed? It is ran straight to the battery. I wouldn’t think it matters.

@MrStangdawg 2 месяца назад

correct resistor only needed for 2G (87-93) or 3G alternator. 1G alternator (79-86) will not need the resistor unless it's been upgraded

@CarsFoodWeed 11 месяцев назад

is there a way to change the backlight to green instead of white?

@MrStangdawg 11 месяцев назад

Yes it has a whole menu for setting the backlight and needle colors. You enter into the "lighting" setting.

@heathermedd683 10 месяцев назад

Is the 510 ohm resister required when doing a coyote swap, with a Ford control pack, or PBH control pack?

@MrStangdawg 10 месяцев назад

You will not need it when doing a Coyote. Most likely you are using a 2011 and UP alternator and should be a plug in your harness to connect to it.

@kellycarr6296 11 месяцев назад

Promo*SM

@roycewall3663 11 месяцев назад

P r o m o s m