Homemade TRIMMER Bike - 62cc - Motorised Bike 

Waited for new video for a long time... *Great video btw*

Great video! I loved the idea itself, and I want to give you a suggestion on how to increase the speed of the bike. Maybe you need to add some gears or make a gearbox that increases the amount of turns to change the speed of the bike. Keep up the good work 👍

Brilliant. You're talented

Great Job👌 I like this !!

Good job 👍👍👍 Mister Imbus

Very good for uphills.

If only Australian state governments would pull their heads out of their rectums long enough to un-ban this sort of thing. They re-classified all gasoline powered bikes as motorcycles a few years back (each state at different times). Then again, they banned hoverboards, e-scooters, monowheels, etc too. Anything other than a 250W or lower e-bike is "unsafe" - unless you're a company renting them out, that is. A pity as they're great cheap transport and good fun as well.

Nice project

Only two little bolts to secure the engine is very sketchy at best. You have four mounting bolts. Use them all. It's only a matter of time before those two overstressed bolts strip out or fracture, causing total loss of the engine. Other than that, its a great idea.

Great! Thanks for share. The engine should be under the height of middle of rear wheel.

Good video broo

A worm drive? Bet that produces a fair bit of torque.

Great job. I am wondering what would be the result adding a clutch+vario combo instead of a "constant" ratio pulley. Those engines are pretty powerfull (2 to 3 hp) which is the range for most 50cc mopeds. Top speed is quite low, which might be due to lack of torque. A vario may improve both acceleration and top speed, but it is just a guess...

Very clever, but a lot of weight in the wrong place, watch out for wheelies! Love and peace.

It is the most ghetto pile of trash! yet it works and is freaking awesome! I love it lol!

Neighbors are probably in Vastorg

I think the reduction gear set up hurts the overall performance have you seen a 60 cc two stroke dirt bike they rip

Why do you have such a powerful trimmer?

Salut, d' ou provient la pièce qui fait le système de renvoi ?

Where did you get the gear reducer? Make? Brand?

What is the gear reducer from?

Weak engine mount without stiffeners, it breaks off the base!

El 3ro

Taj reduktor "protok Vinkovci" je tako nekvalitetan da ne vjerujem da će izdržati dva dana na tom biciklu.

You have no support for that engine to hold up especially for your welds

Why gear reduction?

Ссылку на червячный редуктор дадите?

gearbox link please

With A 62cc Motor, And Having The Correct Drive Sprocket & Wheel Sprocket Direct Chain Drive Would've Been Faster.. imo. (I Remove The Clutch as well, And Just Pedal The Bike to Crank Engine.. Shuts Down When You Stop.. But, For Speed It Works Better)... Still Very Cool Design Tho !!!

Boa tarde companheiro. Tem um patinete elétrico quero transformar Motor a gasolina consegue passar o seu contato

What is max speed?

jako seksi volio bih probati voziti to stvorenje

!!!!!!!!!!!!!!!!!!

26:1 reducer is too much IMO

top speed more like 15-20kmph highly inefficient as it uses worm drive gearbox 80 % efficiency and belt drive also very inefficient motot should be mounted directly to gearbox

🙈🙉🙊

scarsissimo

... зачем нужна эта 2х тактику вонючка?-, ставил бы сразу 4х тактный движок!!!

Xddddd 62cc?? Stupid bait