How To Adjust Your Paint Gun 

This was awesome! I was literally going to my DIY booth to spray some primer for about the 2nd time and remembered that I’ve never really sat down and learned the dialin process. Thanks for putting this together!

The perfect short video on adjusting your paint gun

Great video, no unnecessary filler. Thank you.

Great video! As a novice, this is exactly what I was looking for.

This work perfectly I have the same green gun,x2020

Awesome video. Russ knows his stuff!

Nicely done, simple, straight forward and informative. Thank you.

one thing I did for my airless was get an old plywood plank and started to staple those free brown paper and cardboard from packages to it then I can tear off the paper as I use it and I don't have to "store" the paper

I really enjoyed this because I don’t know how to operate one and I learned a lot hmmm some. Painting in the future on the way he he. Thanks Russ.

I HAVE WATCH A LOT OF VIDS ON SPRAY GUN SETTINGS AND HAVE TO SAY, THIS IS THE BEST EXPLINATION OF ALL THE OTHER. NICE VID AND THANX FOR THE TIPS

Best video I've seen so far, thanks. I'm spraying acrylic in garage for the first time and I don't want to waste any of it. Definitely going to spray some thinners through gun to set up before putting basecoat down!!!

Good advice. I set my pressure at the air compressor's outlet but didn't realise the gun itself may not be letting enough air through so I'll try opening it right up. The manuals for these aren't great, they tell you what the adjusters are for but not quite what they do like you have here, thank you.

Great video. Thank you

Excellent Video... Thanks 👍🏻

Great Video Thanks

So gread job sir thank you

Thanks alot bud!!

Great video. I've never heard about spraying the pattern horizontally to check that the volume is even. That's a great tip. I've had some trouble with tiger striping at times and I think this will be very helpful. I'm usually around 30 psi at gun with single stage acrylic enamel. Is that about right for that type of paint?

Thank you your video 👍👍

Thank you so much for the explain

Lolol trying to make a good gun look bad very informative vid thanks

Praise the Lord. I may be able to dial mine in now.

This was good

Best video of set up I have seen!!!!🎉A++++++

Im still learning. I laid down some epoxy primer and it came out great. I laid down black urethane and it was textured! I probably need to mess with the knobs and also my spray tips.

I have to agree with some of the comments, a short and to the point video great for beginners which I am too. Thank you. Did not think to pour some thinners into the gun and test the fan pattern before paint is used. A question though, will the fact that paint would be a bit more thicker than thinners will that drive the need to adjust the gun for paint or am I over complicating/thinking it? T

Can acetone be used as a cleaning agent? Planning to run acetone through my new gun. First timer. Have two fenders and a good to paint. Great video thanks!

Smart.

Is your air hose leaking air or what’s hissing

Once set, won't the fan pattern for straight solvent (thin) be different than when thicker paint comes out?

Are the guns better when they are gravity fed or with the container below?.

How is the results when you spraying with the air green spray guns?

What compressor are you using and does the gun cfm always have to match the compressor cfm or can you just get close to it? Thanks.

Who are the 3 idiots that gave this a thumbs down?

None of the videos ACTUALLY tell you how to set the gun.....They go directly to the spray...