No video :(

How to fix a broken stud in the frame. Trailing arm bolt broke in the frame.

Подписаться 38 тыс.

Просмотров 9 тыс.

50% 1

S3E16 In this episode I will show you how to repair a broken stud right inside the frame, I will drill the old stud out and tap new threads and screw in a new bolt.
How to fix a broken stud in the frame.
Trailing arm bolt broke in the frame.
Trailing arm stud broke.
How to fix a broken bolt in the frame.
Broken bolt in frame.
How to fix a broken bolt.
How to drill out a broken bolt.
How to re-tap a broken bolt.
How to drill out a broken stud.
Broken bolt.
Broken stud.
Broken bolt repair.
Broken stud repair.
Broken bolt removal.
Broken bolt extraction.
Broken stud removal.
Broken stud extraction.
How to remove a broken stud from a car frame.
How to remove a broken bolt from a car frame.

Опубликовано:

13 мар 2023

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 13

@andrerodriguez7603 Год назад

Thank you very much for the fix. On my 1981 Scirocco, someone over tighten one of the two stud bolts at the rear of the A-Arm, and broke it off, looks just like your situation. I’ll try your fix.

@angeloabela5632 Год назад

Well job like that, I usually use a reverse bits

@LaBeardedGamer 11 месяцев назад

job well done good repair should be solid for years to come its nice VW gave us that access window I have a mk2 golf with a broken weld on the captives nut for the subframe chassi leg

@jayareperiod7101 11 месяцев назад

This will help me with my lower control arm

@BplexOnline 2 месяца назад

This is good but what if i just whant to remove the bolt without having to redo the tread

@SupportingPassion-ug2dh Месяц назад

Hi. will this be safe for the long run?

@gabeagueda-furman535 6 месяцев назад

Good shit mann

@addminusDIY 11 месяцев назад

Same happen to my rear subframe after lowering to replace my strut assembly now i need to do that slowly and patiently 😂😂. I went to shop they dont remove broken bolts

@DeeJayHouser1 Год назад

Aren't you supposed to be doing this in low speed? It doesn't get the bit as hot and dahl it up, but maybe $15 bits are different.

@pum882 Год назад

The metric threads don't need a chart, just some basic math. M10 x 1.5 stands for 10mm nominal diameter, and 1.5mm/turn pitch. Subtract 10mm-1.5mm=8.5mm and you get the drill size

@ProblemSolverGarage Год назад

Where were you yesterday lol