How To Install A 1320 Junkie Intake Manifold And Drilling MAP Sensor 

Just putting it out there I used a dewalt multi tool to cut off fins it work awesome had very little sanding to do

Pretty dope edit good job Derek.

How did u mount the map sensor? I saw you drill it , then it was mounted, if you could please share how it was mounted thanks.

Do you guys sell those svtftw shirts I’m interested in one

I like that pep from 0 to 60 and at lower rpms. Will this manifold kill that range and you only really feel the gains at high rpms?

Also how do y'all fill about imrc delete I emailed my tuner and they said delete ? I'm running 18gt intake on 15 150 5.0

Did you get any codes after installing the intake manifold?

What’s that thing you added on the drip tip?

Had to settle for a 2021 3.5 ecoboost wanted a v8 so i could Supercharge it later nothing was in stock and there was a 9 month wait time if ordered. After i use up the warranty I will check out some mods seen the 3.5 with a tune get over 500HP.

I assume the 500HP is an estimate for flywheel?

What size is the hole for the map sensor?

How did you route the vac lines

Step bits suck for drilling precise hole.

Way too lose. Smoke test will show up. I got a customer truck now that done a BOSS 302 intake. Horrible way of doing this. Lean condition having to compensate with fuel. I'm having to fix this issue now and tune it properly. Had so much RTV over it the RTV company gave him stock options with the company because so much was used