In todays video we John Terry and I show you How to Install Functional Lower Brake Vents from ACS Composite on a C7 Corvette. Since this was John's Car I made him cut the Big Holes in the sides if the car!
Well done 🤙About to tackle this project tomorrow! I've been putting it off for a couple of months, with all that cutting. It's intimidating. I liked his suggestion of using aluminum tape as a precaution too! I've got PPF film on that whole quarter panel, so I most likely will cut a large section of it out before the Dremel. I just did my rear diffuser fins and now onto the functional Ductwork on my Z51 🙌
He is using a sanding barrel tip for finishing but a cutting disk for the hole. The cutting wheel comes in large Dremel kits but you can get on Amazon or Home Depot
