How to Install KTM Front Brakepads at Home ? | Nikavi Brakepads Review 

Yes, but you can't clean the grime and brake dust though.

Thank you

12mm. I have mentioned in the video.

Excellent. Using it for past 3k kms. No issues.

Push the whole caliper towards the wheel before removing old brake pads. It will be difficult after removing.

Yes they use same

Almost same performance as per my experience.

Thank you so much 👍🏽

No, petrol will dry up the rubber rings around the piston and can cause brake fluid leak. Best to use brake cleaner spray.

Caliper spring will keep the brake pads in place. The noise is because it is moving around. You can try installing the spring back.

Change brake fluid and check piston free movement. Maybe bubbles are there in the brake hose. Take it to mechanic and replace fluid.

These are not sintered but better than stock bajaj brake pads used on Duke 200/250. Stopping power is good.. bite is also good for sudden braking.

@@eb_reviews thanks for info!

This are ceramic breakpads

390 mein power zyada hai aur ABS bhi. Aap original KTM use kijiye. 200 mein Bajaj wala chalega.

First check brake fluid is at proper level in resovoir. Next remove both brake pads and rub sideways on 220 grit sandpaper. Put it back. If braking is still bad, you can try brake bleeding as a last resort. You'll need 8mm ring spanner, Clear rubber hose and a empty half litre bottle. And a friend to hold down brake when you open/ close the valve. You can watch other videos on doing this as I haven't made one yet. But recommend you go to mech.

@@eb_reviews thank you so much. I'll try this today itself. Thank again

No

New 390 must be using cintered brake pads. Normal ones supplied by Bajaj are 375rs.

Yeah they are sintered

Bro what about rear brake pads