How To Install Taran Tactical Accuguide Extended Carrier, Safety, And Bolt Release On Benelli M4. 

Thank you man much appreciated.

@@JosephX143X no you will not have to. You can slide out the trigger assembly and immediately start on the safety replacement process without taking apart the trigger assembly. You will need a roll pin punch that fits that roll pin though otherwise you could risk damaging the roll pin and the safety might not work as smoothly.

You got my sub!

@@joshuabartz9051 thanks for the sub man! Yeah I knew it was supposed to be tight but that thing was ridiculously tight in there. I didn’t know they had a specific punch for roll pins. How does the video appear on your screen? When I watch the videos I can see them in full screen vertically on my phone. Are you saying instead of upload them vertically, to upload them horizontally? Thanks for the criticism, I appreciate it. Helps me learn and provide better content for viewers.

@@GearAndGuns when you go full screen at the beginning of your video, muzzle points up. So essentially you can record it however you want, you just have to remember to rotate the video in post processing. As far as the roll pin punch, it has a rounded dimple on the end. You can get a RealAvid, or wheeler, or really whatever set you want. They all work the same. Some bend a little easier though. I know you paid bank for the vortex torque driver. Punches are cheap in comparison. Build your tools up and keep pumping out videos my guy! 🍻

@@joshuabartz9051 okay I understand. I’ll try that on my next videos. I appreciate the criticism. I checked out the roll pin punch set, they both look nice. This was the only time I really needed one. That vortex torque wrench is the nicest one I’ve used, only complaint is it only goes up to 50 torque pounds. Will do. Thanks man! 🤝🏼

The more work you start to do on firearms, if that’s what you enjoy, the more you will run across roll pins. AR platforms use them as well. On the torque drive, I haven’t seen anything go past 50 inch lbs. that’s quite a bit of toque on a bit driver.

I just made a separate video for that. Check my RU-vid channel and you’ll find it. The title is how to remove round retainer clip or bolt release on benelli m4.

It’s benelli m4s new updated hand guard for there new benelli m4 t pro “gen 2” model.

Possibly. I don’t know forsure.

That’s the factory hand guard that came with the t pro “gen 2” model.

I’m sorry I don’t understand what you mean

@@GearAndGuns The Video orientation.

@@MarcoNoPolo yeah I’m sorry man. It was the best way to close up of the gun. It works fine on my phone but maybe not great for computer

I'm sure you're right. I watch 90%+ of everything on my computer. @@GearAndGuns

@@GearAndGuns No worries. 👍

I did what I can man. It’s a video. You can follow it by looking what I’m doing in the video if you can’t understand what I’m saying. I don’t know all of the parts names. I’m not a big time RU-vidr. It’s a better teaching video then nothing. If it didn’t help you, sorry about that. I did the best I could. I’m still learning and just doing this to help how I can while in my own process of doing this stuff.

​@@GearAndGuns I thought it was a solid video dude. Followed it step by step for the taran tactical safety and lifter

@@lambchop6210 thank you! Still working on information presentation and overall knowledge to put out better content.

Guy needs everything labeled and catalogued before install.

@@LosDoyerss lol I guess so