How To: Remove the Governor from a Honda GX160 Motor (Mini Bike Motor Build Part 1) (J.O.A.T.D) 

Thank you. You did an excellent job explaining and showing how it's done.

Good job, good explanation. Thanks for taking the time to do it.

Thanks. Good for reassembling my governor. I removed the gear shaft by drift pin and hammer from outside, must remove flywheel, shaft reinstalls fine (seemed easier then removing clip).

Thanks for the detailed explanation 👌🏾

Thanks a lot bro that was so helpful

Great tutorial.

great vid, thank you

What type of speed increase would you see from this? I have a Jiangdong 5.5hp which is a Chinese clone of the gx160 and I want to do it if I get a substantial increase in speed

Very informative video right there, what is the size of bolt in that crankshaft hole in the middle. To lock the pulley in place.

How strong is the stock rod on the gx160?

I remove the plastic gear from my enegine but not the governor is it fine whitout it?

nice vid! Does getting rid of the governor give you throttle control?

hi, do you think we need to upgrade the engine oil grade after removing this governer?

Use a Dremel

Why they use this governor? What is doing?