How to Replace Clutch Slave Cylinder - Honda 

This is how clear of instruction videos must be . Good job . I can go change my clutch line and cylinder.

i thought that this was some european channel until i spotted the ph12 engine code, well made video and very helpful as i need to replace my clutch cylinder soon

you didn't need to shave a 9mm wrench to fit, simply buy a 3/8" wrench, its sits in between a 10 and 9mm. Japanese use Imperial sizes, with the larger nuts you can get away with using Metric wrenches aka in mm, but with the smaller sizes, you should use imperial or you risk rounding off the nut

I can do now by myself..thank you for sharing us..i will watch later how can i bleed it..thank you

Great video man! Very clear and informative. Time to go replace mine!

Good video. The cylinder is similar to Honda Fit GD's part.

Nice video! My client's own had a similar issue so I bleed the clutch and still to no avail. I've even replaced only the kit inside the upper clutch but the problem of a sponge clutch and no gear still persist. I've checked scrutingly for signs of leakage carefully while someone press the clutch pedal and found out that the down clutch nipple doesn't hold clutch hydraulic fluid! It goes out gently, and also the clutch fluid was replaced with a new one. Nevertheless, it's still very darkened in color. Please, how do I fix the issues? Darkened fluid, soft clutch pedal, and a most especially the leak at the down clutch bleeder or nipple.

Thank you so much for sharing bro!

Buen vídeo y gráficamente bien explicado con detalle 👍🏻

I have a 95 D15b7 engine. Is this the same? He did say D series.

Ang Galing! 🙏 Salamat Po.

What if it doesn’t have a flare nut and has a pin instead? I got the old one out but I can’t get the new pin back in, any tips?

I was wondering if I needed the dust boot right away or can I go a little bit without it?

Great video! question did you have to push the push rod in when installing it? I notice if i dont push it the wholes on the bottom do not line up?

No…..don’t drain all the fluid. Just do a quick swap. Then flush so you don’t have to try and get all the air out. Also getting dirty degreaser in to your clutch plate is a bad idea.

Nice job

Thank you👍🏽

What is the thing floating in the reservoir? I don’t have one.

Why do you drain the oil when trying to do is bleed the clutch

Hello! How did you know that you have to replace that part? What was the symptom when you were driving?

I am a clutch hydraulic expert.....

Absolutely get a slave cylinder with a double ring double seal piston with two O rings You need to be double it possible

my cylinder isn’t moving at all ? I replaced that and it wont bleed now