Unfortunately my error is related with the machine not sending proper voltage to the unit water valve. Getting only 6.8 volts at the valve. Auger motor isn’t running either. Believe wiring harness issue somewhere
Problem was located in the top right connector above the door next to the hinge. The large connector came loose, installed a zip tie cross ways to hold tight and it works great now
Thanks a lot for such an informative video! The video shows the new manifold along with the white exterior where the screw fits. The image on the website, does not seem to have it neither on the official GE parts website. Is there an easy way to remove the while exterior from older manifold and fit it into a newer manifold? Thanks in advance!
Thanks a lot for your comment. I was worried the plastic cover might break off. The removal of plastic sides took the maximum time of the repair for me. It came off eventually, and now the repair is completed.
I noticed the part only includes the manifold and tube but it appears to be connected to the white housing that is screwed to the fridge. Can you show how to install the manifold to the white housing or is it a simple pull to remove and replace?
@@PartsDr look at the video where the manifold is attached to the white case that screws to the fridge, the manifold part only has the grey part without the white plastic that has the screw to the fridge. Does that make sense?
Can you guys tell me which side is input and which one is output? I'm going to use a dumb xwf head in between my lines, so I can use cheap xwf filters for my evil ge fridge. I mean "genuine parts detecting" fridge.
We aren't sure what you are needing help with, but if you are looking for this part we have it on our site here: partsdr.com/part/wr51x443-defrost-heater-thermostat
