Husqvarna 435 Chainsaw Low On Power 

It’s hard to tell what sounds are sometimes. But your description, I was correct. Thanks for making going to work a fun drive.

Holy smokes, What a job!

Very involved repair. If it was me I believe I would have bought a little bit bigger new saw. Awesome skills ! !

Holy cow! What a laborious job Scott, some shops around here wouldn’t go that far to work on an issue such as this one. I can really appreciate your patience and effort to show us all of the fine details. Later

Good call by the ScottsMan!

Great job, Scott ! Well spotted 👍🏼

Great vid! Good catch on the first start, I’ve ‘ventilated’ & sent a few of those bar sheaths across the room…

Great video Scott, thanks!

That is a lot of laborious tare down to get to a rather simple problem. Part on order?

Yep good catch! Clam shell saws aren't much fun for that repair sometimes!

Morning Brother 😊😀👍🏼 I’ve Also Seen The Intake Boot Torn At The Carb Spacer Block On The Carb Side Of The Boot 😀 Good Find 👍🏼👍🏼👍🏼

Awesome job!!

Will you fix it?

Thats rough. Seems like most of the saws I’ve been into, you can sneak that boot off without pulling the cylinder. Then again, perhaps good time to do the crank seals. I’ve not been into the 435 far, just some basic stuff. Great diagnosis.

Great video and very good presentation. May i ask how much is approximately the cost just for the labour?

The ole "processing information" finger tap. I'm my case it's the "contemporary head scratch".

Great video Scott. Gotta say, I have a 357XP and a 460 Rancher, definitely a difference from a pro saw to consumer clam shell saw in the construction side of them. Thinking about an Echo 620P but but then Chris from In the WoodYard showed off his new 562XP Mark 2… my biggest issue is dealer support here in Michigan. What are your thoughts? They both look to be great saws.

Hey Scott, another fantastic video brother. Did you recently say that Husqvarna had upgraded their fuel filters. What is the part number of the fuel filter you used and is this filter common for other saws as well. Thank you for your time sir.

I watch u in 2x speed just so ya know lol as do when I watch myself. I like your video neighbor LATER

Rewatching and I noticed how you talked about fuel filter. I had one in particular that the saw starved for gas. Filter looked perfect. Checked and found only breathing through top a little. How do you verify it is good / bad. Thanks.

Seems like a lot of work for that intake boot. Is a re-seal and put together with a new boot economically feasible for the customer?

Great vid... What's the easiest saw in the cc class to work on?

Why is my chainsaw Husqvarna 390 xp died down when I giv full power?

Is that a common problem with this model?

Did you se what caused the boot to fail?

Thanx a lot! Will u tell me u r snap on impact drive model?