Modern 3 phase scroll compressor or older ones 10 tons and above if you have to replace a defective motor protector or installing a new compressor then you must be familiar with this device... PLEASE LIKE AND SUBSCRIBE
I'm having a issue with connector not pulling in no 24v. I have 24v to m1 and m2 goin to compressor. If I jump m1 and m2 the compressor will start. Also if I put 24v to coil connector it'll rn just fine.
My old system ZP182KQE-TFD-477 does not have the Coresense compressor protection and said they don"t make that model anymore, Instead they provided with ZP182KCE-TED with Coresense . (The only difference is these models is the motor protection. TFD has the internal motor protection. TEDhas the newer, updated Coresense module. "F" is internal protection. The "E" is electronic enhanced. How can I wire this?
Yes, and if there’s no redundancy on the compressor, then it would have to be replaced thus i would replace the module first just in case it’s malfunctioning
Very nice explanation, Will the compressor start if you don't use the t1and t2 or m1 and m2. I changed out a trane compressor to a Copeland and the trane does have the core sense...
can you please explain how wire core sense to compressor ,solenoid, low and high pressure switches ,hot gas t1 and t2 , m1 and m2 i mean full wiring to compressor components.please need it AsP
If the terminal T1,T2 not use ? Safety device not work (ok) . I do not use safety device. Machine direct supply this terminals (L1,L2,L3) what is possible without safety device compressor work only ?
wasi Ahmed The module will not protect the compressor if t1 and t2 not connected, if you wish to protect compressor apply the appropriate power supply to t1 and t2 (24v or 120/230v make sure correct voltage!) then connect m1 and m2 in series with high and low pressure switches
Are M1 and M2 the ones you can jump out if the module keeps giving nuisance trips, but you want to keep compressor running until you get a new module? Daikin AGZ alarm OffMtrProtect.