Hyper Tough HT300. Cheap and simple code reader. 

Great to hear!

Damn brotha mine was only 20!

I have used it works great

@@henrygibson1530 nice

Glad it helped. 👍

On the directions, it says don’t start your vehicle but on your video yours is running

@jeffyoung3528 you can read and clear the codes with the engine off. For the real time data it needs to be running.

Glad you enjoyed it. For how cheap, I was surprised how many features it has.

I'm glad it helped.

Does it clear engine light

It does thank you

@@markgreeley37 yes it does

So whats with the red icon flashing but no codes. Mine is doing a 02 and cat icon in red ?

$20 is a steal. For a cheap walmart scanner, it has quite a few features. Good score.

You likely bought the HT100 model and not the HT300 model.

After you clear all codes some systems, like evap, have to cycle and run for an extended period before the pcm determines if it's working properly. It is stating it's not ready or reading

Can't say I've looked for that menu option. Should be in with the beep volume, brightness, etc. I would think

Yes, it can. It clears the trouble codes, and if the problem is fixed, it will stay off.

emissions testers can see if the code has been cleared

@novacane219 Correct, you need to drive for another good 30 min after clearing codes before it will give an all-clear on emission test. If you clear a code and go straight to a test center, it will show the pcm isn't ready for a test. Thanks for bringing that up 👍

Will it clear srs airbag light and tell you where the problem is located ?

@sooner1148 no an airbag light would need a scanner like a snap on, launch, etc. This is emission or engine trouble codes only.

No, your battery needs to have a charge for it to read the cars computer.

Ok thank you 😊

No, it is emissions related/check engine lights only. The real time data may give you some hints like air/fuel ratios, load %, etc, but it won't tell you more than that.

Ok another thing is it is not showing me my MAF readings. It's not even in the list lol ​@macsboneyardbuilds

@MrSkabzzPranksAndChallenges I don't recall exactly what it can and can't read. It's real basic and won't tell you everything that's going on. You may look on Ebay for a used Autel or Snapon that has all the functions for cheap.

If you have lost acceleration and power, have you performed a compression test? Fairly easy to do, can even rent the kit from auto zone

Not that I have found. It does show when a system is not ready/recently cleared. If you or someone else goes in and clears all codes, all emissions systems will show red in color. Once it runs and is driven, it will slowly start to check them, and if it's working properly, they will turn green. If something is still not fixed or corrected, it will stay red and throw the MIL light again.

In your app store look up repairsolutions2

@@macsboneyardbuilds If I searched for it, and only "car scanner" appears, with the checkengine error logo

@mickyquiroga3517 no, it's by Innova Electronics. Has a gear with a number 2 in the middle. repairsolutions.com/

I believe what is displayed is all it has. I have not found a menu to be able to change which parameter it reads.

If you use the app you get a lot more features that’s just what’s on the tool itself 👍