1. Introduction
This SOP provides a step-by-step guide to perform a rotational Auto-Tune in IMPULSE®️ Series 5 drives.
2. Procedure
2.1 Understand the Rotational Auto-Tune
Understand that the most frequently used Auto-Tune process is the rotational Auto-Tune.
For optimal rotational Auto-Tune, motor should be de-coupled from the drive train and the holding brake(s) must be released.
2.2 Access the Auto-Tune Section
First, hit the menu key and scroll down to Auto-Tune and open it up.
2.3 Select Rotational Auto-Tune (T01-01=0)
Go into the Auto-Tune parameters and select rotational Auto-Tune. (T01-01=0)
2.4 Enter the Motor Nameplate Data
Complete remaining T01 parameters.
2.5 Confirm holding brake(s) are released.
2.6 Start the Auto-Tune
Press the green run key. The series 5 drive will energize and rotate the motor.
On the Series 5 drive display, there’s a bar graph that indicates how far along the Auto-Tune is proceeding. The drive shows the frequency output and the current output.
2.7 Complete the Auto-Tune
Upon completion of a successful Auto-Tune, the series 5 drive will show “End Tune Successful” on the display.
3. Conclusion
This SOP provides a basic guide on how to perform a stationary Auto-Tune in IMPULSE®️ Series 5 drives. Always follow the steps in order to ensure a successful Auto-Tune.
Access more CMCO training from our Magnetek team here - motion.cmco.co...
Full Series 5 Troubleshooting Video Playlist - motion.cmco.co...
15 сен 2024