Isnt the bike already DC? How come you needed the rectifier? I installed a baja design harness to a LED headlight and now the light strobes super fast at idol, just wondering if you ran into that sort of problem, thanks
I have to remove my stator cover to retrieve a snapped off case bolt. Will I need a new paper gasket? Can it be replaced with a better one? Whatre they called? Thank you Not changing the flywheel or stator yet for lighting. Although I will in the future...
Yes you will need a new gasket. But before you do that I would try buying one of those really skinny extendable bag is from hardware store and sticking it down along side of the cam chain whilst the bike is leaned over on its stand. You should be able to retrieve a broken off Bolt from a case fairly easily without splitting the engine apart.
I did but it sucked so I took it down. Honest I found it better to plug the new stator into the stock wire harness and tap the battery power wired from the lighting harness directly into the stock capacitor.
Hi. I have a question about the stator on your Crf450. (Might be a stupid question but I do not know the answer) Is it normal for engine oil to leak out where the stator cable go in to the left crankcase cover?
The stator is a stock core from ebay rewound by ricky stator. The rectifier is a trail tech single phase relay switch regulator. I found I wasted a lot of money so if you don't mind me asking, what lights are you planning to install?
How did you end up doing all the wiring for that. I have the same bike and stator kit and after wiring it, it seems I don't have a spark anymore cause the bike wont start. Any ideas what I did wrong. Do you think a bad Reg/Rec could cause that.
desert speed it is a kick start so the battery should not effect if it gets spark correct. Also I have had several people look over the bike and they all say I wired it the same.
You wired in the supplied harness, reg/rec, and battery correct? You didn't just plug it straight into the 6 pin harness off the bike like I did for (poor) demonstration purposes right? Also make sure that square 2 pin white female plug on the supplied harness replaces the capacitor connection.